10Bar GF1 Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Kamera 10Bar GF1. 10Bar GF1 9 halaman. Underwater housing for the panasonic gf1 camera

Halaman Cetak

Mode Lever before install the camera into the housing.

(4) Mode dial – switching the mode by press and rotating the button.

(5) On / Off – align the white dot towards the lid, press and turn the button to turn on and off the

camera on

(6) Motion picture button – press the motion picture button to start the recording

(7) Shutter – press to activate the shutter

(8) Key Hole Lock – press down and turn to lock and unlock the lid.

(9) Flash on – press the button to open the flash. Make sure that the Flash is turn off with lever (1)

before take out the camera from the housing.

(10) Playback – Press the button to activate

(11) Rear dial – gently press and turn to rotate the dial, press down to select or change mode

(12) [AF/MF] / [Q.MENU] – turn to select and press to activate the function.

(13) Cursor – Rotate until the white dot is over the required direction and press, when not in use

rotate the white dot towards the screen to facilitate the Menu Set function

(14) [MENU / SET] – Rotate until the white dot align and press, when not in use rotate the white

do downward to facilitate the "cursor" function

(15) Display / Delete / Preview – rotate to select and press to activate

(16) Housing lid – monitor display

(17) Zoom – press and turn to activate the zoom function

(18) [O.I.S.] Switch – press and turn to toggle on and off

(19) Focus ring – press and turn to adjust the focus

For the full list of camera functions and settings accessed by each control, please consult

the Panasonic GF1 camera instruction manual.

4. Set up Instructions

4.1 Special note on responsibility for watertight integrity

Each housing is individually inspected and hydrostatically tested in the factory. The design of the

main piston O-ring seal is among the most reliable in the industry and the watertight integrity is

excellent. This special O-ring design provides a perfect seal even if there is any movement

between the body and lid due to change of ambient pressure. However please note that

responsibility for ensuring the integrity of the watertight seal lies entirely with the user. 10BAR

accepts no liability for damage to, or loss of any equipment used with, or placed inside the

housing. Users are highly recommended to carry out in-water test of the housings without

installing of the camera for their first dive, after change of new ports or alternation of any new

configuration. The test can be carried out by lowering the housing with ballast to the working

depth or dive down to the safe diving range.

The O-ring seal is the main barrier between the water outside and the air space within