Aero-Pac APT4000 Panduan Operator - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Operator untuk Skuter Aero-Pac APT4000. Aero-Pac APT4000 5 halaman. 24v aircraft towunit

ADAPTER MOUNTING

1. Place the adapter bars into the open ends of the Aero-Pac APT4000

towbar frame, and lightly tightly the screws.

2. Approach aircraft from the front allowing adapter to fit nose gear

as needed according to plane type.

3. Secure the adapter to gear depending on adapter type

and tighten accordingly.

4. Check plane area free.

By putting the pin in the left or right hole. You can adjust the height, left hole is

recommended for strut attachments the right hole is recommended for axle

attachments. Make sure there is a certain angle, like this you create some

downward pressure on the tires.

Practice Is Highly Recommended: Operating your new APT4000 prior to hooking

it up to the aircraft is essential. Get familiar with the APT4000 by operating it in

forward and reverse and at different speeds.

Then try moving the aircraft in an open area.

Do not attempt to park the aircraft in a tight space until you are thoroughly

familiar with the APT4000.

Always check for clearance around the entire aircraft prior to moving the aircraft.

Wheel Bearings: Should receive light oil a few times annually.

Operating Speed: The electric APT5000 is designed to operate at a slow walking

pace for safety (max 7 Km/hr) .

OPERATION

The towbar units works and the principle that you need to press the wheels to

the ground by pressing the handle. Otherwise it is impossible that the APT4000

of about 30 kg (64 Lbs) can pull an aircraft of more than 1000 kg . It is

important not to proceed fast initially, the aircraft has a certain inertia, so let the

airplane move first and then increase the speed by turning the control handle.

The selector is to select forward or backwards, Left is forward, right is

backwards.

By turning the black handle, you select the speed of the unit. From 1 km/h up to

7 km/h.