AeroBed R111 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pompa Air AeroBed R111. AeroBed R111 8 halaman. Au / rdv pump

IMPORTANT: THE FIRMNESS OF YOUR AIRBED MAY

DECREASE AFTER YOU INITIALLY INFLATE IT. YOUR AIRBED

IS NOT LEAKING. THIS IS NORMAL AND IS CAUSED BY THE

MATERIAL STRETCHING AFTER THE AIRBED IS INFLATED.

ADD AIR TO MAINTAIN YOUR DESIRED FIRMNESS.

NOTE: BED MUST BE AT ROOM TEMPERATURE PRIOR

TO INFLATING OR IT MAY CAUSE AIR LEAKS. PRESSURE

CAN VARY DEPENDING ON ROOM TEMPERATURE AND

CONSUMER WEIGHT.

Place your rolled-up bed on the floor or other surface free of obstructions or sharp objects.

Make certain the Quick Release Valve is closed. Bed should be stored with valve in the closed

and latched position. If the Quick Release Valve is open, close it by using 2 thumbs to push

cover and snap into valve. Be careful to avoid pushing valve cover to the right or left as it snaps

into the valve opening.

This is the closed

position.

Remove the AC plug and cord from the plastic bag and shrink wrap.

Plug into any standard polarized 240 Volt AC electrical outlet. This

product electrical rating: 230V AC, 50 Hz, 0.8 A.

Note: Because this is an electric device,

ensure your hands are dry when connecting

the cord set to the pump or plugging it into

the wall outlet.

NOTE: ALWAYS FULLY INFLATE THE BED BEFORE

ADJUSTING FIRMNESS LEVEL.

Press and hold the UP arrow (Inflate) on the control wand to inflate your bed

to the full (firmest) capacity. Do not over inflate. Once bed has reached desired

firmness, then release the arrow.

Lie on your bed and use the Control Wand to adjust the firmness to your

desired level. For firmer bed, press the UP arrow (Inflate). For softer bed, press

the DOWN arrow (Adjust).

INFLATION

Open Quick Release

Valve.

Close valve using 2

thumbs.