Aerobotics AeroHawk Panduan Penerbangan - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Penerbangan untuk Drone Aerobotics AeroHawk. Aerobotics AeroHawk 15 halaman.

Installing the Battery

The following procedure is to be followed before each flight. After the flight, batteries should be disconnected and

removed from the AeroHawk for transportation.

1.  Power on the radio controller. Ensure that all

switches are in the up position and that the

Throttle & Rudder Control stick is in the down

centre position (See Radio Controller

schematic).

2.  Open the front compartment by pushing the

latch towards the nose and lifting it up at the

same time.

3.  Place the battery into the battery compartment by

sliding it in above the Velcro and then pressing

down to secure it to the Velcro (Note: you might

have to shift the battery forward or back to ensure

the AeroHawk's center of gravity is correct, see step

4). Ensure that the battery is secure so that there

will be no relative motion in-flight.

4.  Getting the center of gravity of the AeroHawk

correct is extremely important to ensure a good

flight. Place your fingers on the CoG marker (a

sticker or a small bolt) under the wings. The

AeroHawk should balance level or at most 5

degrees nose down. If not, move the battery forward

or back and try again.