American Sanders AVAC18 Panduan Operator - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Operator untuk Penyedot Debu American Sanders AVAC18. American Sanders AVAC18 20 halaman.

Halaman Cetak
The components of the collection tank are as follows:
1. Collection tank.
2. Front pivoting wheels.
3. Rear wheels.
4. Vacuum motor control switch.
5. Exhaust air noise reduction filter.
6. Control handlebar.
7. Collection tank lid coupling - uncoupling hinges.
The stages for making the appliance safe, thereby making it possible
to carry out operations safely, are as follows:
1. Make sure that the main switch (1) is in the rest position, if not,
disable it by pushing the switch to "0" (Fig.1).
2. Make sure that the plug (2) on the power cable (3) has been taken
out of the electrical supply socket (4), and if not, disconnect it
(Fig.2).
3. Wind the cable around the control handlebar.
ATTENTION: Users are advised to always wear protective gloves, to avoid the risk of serious
OFF
1
Before beginning to work, it is necessary to:
1. Before using, the appliance must be in order and safe to use
with the work equipment, especially the power cable and the
extension cable. If everything is not in order, the appliance must
not be used.
2. Take all necessary steps to ensure that the device is in a safe
condition (see
MACHINE
SAFETY'").
ATTENTION: Users are advised to always wear protective
gloves, to avoid the risk of serious injury to hands.
1
1
9. Fix the cover to the collection tank by using its hooks (1) on the
side of the collection tank ( Fig. 6).
ATTENTION: The collection bag-filter should only be used for
collecting solid waste.
ATTENTION: When using the collection bag, do not vacuum
waste that could cut it, burning embers that could set it on fire,
or acid solutions that could dissolve it.

LOCATION OF THE COMPONENTS OF THE COLLECTION TANK UNIT

APPLIANCE SAFETY

1
2

PREPARING TO WORK

2
2
1
2
1
injury to hands.
ATTENTION: To prevent any damage to the electrical socket, pull
out the plug (2) from the electrical socket (4) by pulling the plug (2)
directly instead of the power cable (3).
4
3
2
3. Free the cover from the collection tank by releasing its hooks (1) on the
side of the collection tank ( Fig. 1).
4. Remove the cover (2) from the collection tank (Fig.2).
5. Put the cover delicately on the floor.
6. Check that the fabric vacuum filter (3) is inside the tank, if not put it in
(Fig.3).
7. Insert the collection bag (4) inside the collection tank (Fig.4), being
careful to position it correctly inside the filter.
ATTENTION: To fix the collection bag fold the hem around the inlet
mouth of the collection tank.
8. Put the cover (2) on the collection tank (Fig.5).
3
3
10. Insert the vacuum hose (6) into the vacuum nozzle (7) in the cover (Fig.7).
11. Select the most suitable accessory for the work to be carried out.
12. Insert the selected accessory into the vacuum hose.
ATTENTION: Never use the appliance without the filters supplied with
the machine.
12
4
3
2
4
4
7
6
5