12Volt DirectStart CS423 Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Starter Jarak Jauh 12Volt DirectStart CS423. 12Volt DirectStart CS423 13 halaman. Remote car starter 2/ 3 zone intrusion alarm options

Halaman Cetak

INSTALLATION INFO

System Wiring

Transmitter Programming: How to

System Programming: How to, Example,

Bank I Programming: Basic features.

Bank II Programming: Remote start features

Tach Programming: Tach Setting, Adjusting, Engine Crank Protection

Diesel Installation: Description of Options

Safety device Connections: Automatic & Manual transmission Vehicles

Parking Light Status indicators: Flash Codes, # of light flashes & description

Main Wiring Diagram: Wiring Schematic

SYSTEM CONTENTS

1-Base Control Module

1-6 Pin Main Power Harness & Connector

1-3 Button Transmitter (Optional 2

WARNING:

This unit must be installed with all safety devices supplied!!

LOCK – BUTTON # I

Transmitter Battery Replacement

1) Remove screw(s) from back of transmitter. 2) Remove front cover and remove old battery carefully.3)

Replace with new GPA23A 12 volt battery. Verify polarity (+ -). Normal battery life is approximately two years

but can vary depending on use. For best performance change battery once a year.

MANUAL TRANSMISSION VEHICLES

MANUAL TRANSMISSION VEHICL

If remote starter is installed on a manual transmission vehicle, a "READY MODE" safety procedure

must be followed EACH time you exit the vehicle. The safety procedure is in place to REMIND the user

to leave the vehicle in NEUTRAL and NOT in gear before remote starting. If safety procedure is not

completed, vehicle WILL NOT remote start but all other options will function normally.

* AN ON-BOARD JUMPER MUST BE REMOVED TO ACTIVATE MANUAL TRANSMISSION PROGRAMMING AND

SAFETY FEATURES. FAILURE TO DO SO WILL RESULT IN UNSAFE OPERATION WHICH COULD RESULT IN

INJURY OR DEATH. INSTALLATION IN MANUAL TRANSMISSION VEHICLES IS AT THE SOLE DISCRETION OF

THE USER. TRILOGIX ELECTRONIC SYSTEMS INC. CANNOT VALIDATE NOR ENSURE THAT ANY OR ALL SAFETY

REQUIREMENTS ARE MET DURING INSTALLATION AND THEREFORE ACCEPTS NO RESPONSIBILTY FOR THE

INSTALLATION OF ANY REMOTE CAR STARTER IN A MANUAL TRANSMISSION VEHICLE. DO NOT INSTALL IN

CONVERTIBLES, SOFT-TOPS OR VEHICLES IN WHICH DOORS CAN BE REMOVED AND DOOR SWITCH

DISABLED.

CS400 DIRECTSTART

REMOTE CAR STARTER + ALARM

Transmitter)

CS400 VERSION 412

1-Instructions - Owners,Install,Warranty

1-14 Pin Input/Output Harness & Connector

1-3 Pin RF Powered Antenna

UNLOCK – BUTTON # III

START – BUTTON # II

ES: : : :