Canon AE-1 Memulai

Jelajahi secara online atau unduh pdf Memulai untuk Kamera Digital Canon AE-1. Canon AE-1 2 halaman.
Juga untuk Canon AE-1: Petunjuk Manual (22 halaman), Manual Prosedur Instalasi (48 halaman), Manual (42 halaman), Manual (12 halaman), Petunjuk Manual (22 halaman)

Halaman Cetak

Setting the Film Speed and Using the Meter.

Set the Film Speed

To set the film speed, first push

the film advance lever to its stand-

off position away from the camera

body, then lift up the ASA ring

around the shutter dial and rotate it

in either direction until the proper

number is aligned with the green

index mark.

Light Meter

First set the shutter speed to the

desired setting. TIP: For hand-held

shots you shutter speed should be

set to 125 or higher. Then to use the

light meter, lightly press the shutter

release button while looking through

the view finder. Make note of the

aperature setting indicated by the

meter needle in the veiwfinder then

set the aperature ring on the lens to

the setting indicated. The setting will

vary depending on your shutter speed

and lighting conditions.

Rewinding the Film

When the film advance lever cannot travel

all the way to the end of its stroke, the film

counter tells you that you have reached

the end of the roll. You have to rewind the

film into its protective cartridge before

removing it from the camera. To rewind,

press the small black rewind button on the

bottom of the camera, unfold the rewind

crank and turn it in the direction of the ar-

row. When the frame counter has reached

the "S" mark you should stop. Then pull

up the rewind crank and open the camera

back.

Set the Film Speed

Meter

Rewind Button

Page 4

Getting started with the Canon AE-1

The Very Very Short Version.

Check the Battery

Whenever you check out one of our cameras you should verify that

the battery level is good.

The battery level is checked by pressing the battery check button on

the top of the camera while watching the meter needle in the view-

finder. If the meter needle rests below the index mark or 5.6 the

battery level is ok. If the meter needle rests above the index mark ask

the lab aide to replace the battery for you.

Battery check button

Meter needle as seen in viewfinder

Page 1