Euro-Pro EP700 Panduan Petunjuk Penggunaan dan Perawatan - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Penggunaan dan Perawatan untuk Penyedot Debu Euro-Pro EP700. Euro-Pro EP700 8 halaman. Ultra lightweight upright vacuum

For best cleaning results, the dust bag should be changed often. The use of powder carpet
fresheners can decrease the effectiveness of the dust bag filtering system by clogging the
bag and not allowing air to flow though properly. We recommend that hard objects, pins,
broken glass, paper clips, etc. be picked up from the floor before vacuuming. Although, your
vacuum will pick them up, they could do severe damage to the vacuum.
Use genuine EURO-PRO dust bags, belts and filters only, to insure top performance from
your vacuum.
1.
Changing the Dust Bag:
A) Unplug cord from wall outlet.
B) Pull hard-shell body cover (8) off by releasing the latch
(11) on top of the cover.
C) Remove the old dust bag by holding the cardboard
support and pull towards you from the bottom first and
next from the top. Remove carefully to avoid dust/dirt
spilling from dust bag.
D) Take a new dust bag and while holding the cardboard
support push the bag over the opening of the dirt
discharge tube until it is seated against the rear of the
enclosure.
E) Make sure that the entire bag is inside the hard-shell
housing, before closing outer cover. Always check the
filter every time you change the dust bag.
F) Once the new dust bag is in place, re-close the hard
shell front cover by aligning the bottom locking tab
with the slot in the body, close cover slowly allowing
the mid locks to engage, then snap top in place. The
latch will self lock.
2.
Changing the Filter:
A) This is best done while changing the dust bag.
B) Follow instructions for changing the dust bag. Once
dust bag has been removed, peel off exhaust filter,
located behind the dust bag on unit body.
C) The filter is held in place by Velcro strips and is easily
removed and replaced for cleaning.
D) To clean filter rinse in warm, soapy water. Filter must
by completely dry before re-installing into your
vacuum. To re-install, press filter back onto Velcro
strips.
NOTE: DO NOT OPERATE VACUUM WITHOUT FILTER IN
PLACE.
E) Once filter has been replaced, follow instructions for
installing dust bag and closing front hard shell cover.
Maintenance & Care
3
Exhaust Filter