Euro-Pro ULTRA SHARK UV627 Panduan Pemilik - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pembersih Uap Euro-Pro ULTRA SHARK UV627. Euro-Pro ULTRA SHARK UV627 6 halaman. 7.2 volt dc 3-speed cordless sweeper
Halaman Cetak
Changing the Rotating Brush, Gear Box & Squeegee
WARNING:
Use caution when changing the rotating brush and gear
box so that the unit does not turn ON when pressing down
on the sweeper power head.
1. Remove the extension tube handle from the sweeper power head.
2. Turn sweeper power head upside down being careful Not to accidentally turn the
unit ON.
3. Remove the brush cover. (Fig. 13) (Refer to page 5 for detailed instructions.)
4. Push in on the locking tab of the gear box and lift gear box to remove. (Fig. 14 &
Fig. 15)
5. Lift the brush bar end cap up from the slot. (Fig. 16)
6. Pull the brush bar out from the bushing and slip off the belt to remove the brush bar.
(Fig. 17)
7. Insert the new brush bar by first inserting the brush bar into the bushing on the end
opposite the driver belt. (Fig. 17)
8. Slip the belt over the brush bar cap.
9. Insert the brush bar into the slot. (Fig. 16)
10. Insert the gear box tabs into the tab slots and push down until it clicks into place.
11. To replace the squeegee, follow instructions above for removing the gear box and
slide the squeegee out from left to right. (Fig. 18)
Gear box
Fig. 13
Fig. 16
Locking
Gear box
tab
Fig. 14
tabs
Fig. 18
7
HOW TO OPERATE YOUR CORDLESS SWEEPER
1. Before using, please ensure that the cordless sweeper has been initially
charged for 20 hours
Your cordless sweeper will only operate properly when the batteries are fully
charged. Your sweeper will operate for varying lengths of time on a full charge.
This will depend upon the type of surface being cleaned. (Longer operating time
on bare floors vs carpets.)
2. Push the On/Off switch to operate the unit. To turn off, press switch again.(Fig.4)
CAUTION:
Lift
3. To release the handle to a comfortable position, apply pressure to the top of the
sweeper head with your foot while pulling back on the handle.(Fig. 5)
Fig. 15
Fig. 17
4. To change the speed of the sweeper, press on
the speed control button. As you press on it, the
speed indicator light will change. If one light lights
up, you have the low speed for hard floors; two
lights, medium speed for carpeting; three lights,
high speed for turbo deep cleaning. (Fig. 6)
5. Flashing LED lights indicate that the brush bar
system id blocked or jammed. If this occurs, first
turn the unit off, then remove the obstruction
before turning the unit on again.
"On/Off" switch
Fig. 4
Any electronic or electrical appliance should not be
stored in or exposed to areas of high heat or humidity. Do
not store your cordless sweeper close to stoves,
radiators, furnaces or in a bathroom or bathing area.
Fig. 5
4
Hard floors
Carpeting
Turbo Deep
Cleaning
Fig. 6