bocci 16.40 Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perlengkapan Lampu bocci 16.40. bocci 16.40 4 halaman. Tree-like led light

Halaman Cetak

With the anchors in place, spin

Using heavy equipment, orient the

two of the provided nuts followed

tree base in the direction you want the

by a washer onto each anchor.

branches to go, and lower it onto the

Make sure a minimum of 19mm

anchor bolts. Repeat this step for all

(3/4") space for drainage below

nearby trees.

the tree is maintained.

Once all tree bases are in place, level

the bases using the nuts below the

baseplates. Place another washer on

each anchor followed by a nut and

tighten the nuts on top until snug.

Note:

There will be a wire coming from the

middle of the bottom of each base,

make sure that the wires do not get

damaged during install.

16.40

INSTALLATION INSTRUCTIONS

120V or 240V line

12V output

Mount LED drivers remotely and route

Connect the cables to the open slots

output wiring from LED driver to tree

in the terminal block on the 12V side

location using 12GA direct burial wire.

of the LED drivers. Ensure that the

braided outer wires are all connected

Note: Up to 13 pendants may be

to one 12V output wire and all inner

connected to a single driver.

insulated wires are connected to the

other or a short will occur.

Note:

Drivers must be remote mounted in a

Once all the coaxial connections are

close by, waterproof, accessible and

made, connect the line voltage to the

hidden location for ease of long term

open slot in the appropriate terminal

maintenance. Installation to be done

block.

by certiﬁ ed personnel to ensure code

compliance.

ﬂ ush mount

detail diagram

Once all wiring connections are

You should now have an

complete, and the nuts are snug-

upright tree base ready

tight, slide the cover down over

for composition of the

the plate until it rests on either the

pendants according to the

gussets or the ground.

speciﬁ cation sheet.

Note:

Bocci recommends installing the

ﬁ nish ﬂ oor height higher than the

cover plate with a small reveal

around the tree base or alternately

installing ﬂ ush with the cover plate.

Depending on the ﬁ nal installation

ﬁ nish, you may want to ﬁ nish the

ﬂ oor at this point if the ﬁ nished

ﬂ oor can support a lift or scaffold

for installation of pendants. If not,

complete the installation following

steps 7 - 11 before completing the

ﬂ ush mount detail.