Barnes MAK-18 Panduan Petunjuk Pengoperasian - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Alat Listrik Barnes MAK-18. Barnes MAK-18 12 halaman.
Halaman Cetak•
Hold the hand extruder only on the handles
provided for this purpose.
• CAUTION The melt temperature must have rea-
ched the preset start interlock temperature for
the startup timer to be activated. After the startup
timer has timed out, the start interlock will be re-
leased and the extruder can be started.
5.4 Welding with the hand extruder
Observe section "Safety" and the data sheet.
General
Welding is to be carried out in accordance with the
guidelines of the German Association for Welding
Technology (Deutscher Verband für Schweißtechnik
DVS).
The parts to be joined and the welding rod must be
clean and dry.
5.4.1 Introducing the welding rod
• CAUTION The hand extruder is provided with a
bore for introducing the welding rod.
MEK-18 / MAK-18
5.4.2 Replacement and aging of welding rod
• If the welding rod is to be replaced, make sure
• For this purpose, operate the preheated hand
• The DVS guideline also recommends this proce-
•
D02-0001
5.4.3 Welding direction / rate
• The pressure of the discharging extrudate causes
• See DVS Guidelines for the welding rate.
5.4.4 Interruption of work
•
• When interrupting the welding job, switch off the
Issue 08.2008/Rev. 00
that any remaining rod in the hand extruder is
completely removed.
extruder with the new welding rod until clean new
material discharges.
dure for hand extruders which have been out of
service for prolonged periods while still being
filled with welding rod
Ensure safe and environmentally compati-
ble disposal of any waste generated!
the welding shoe (and hence, the hand extruder)
to move in welding direction.
D02-0026
Observe section "Safety".
Do not leave the hand extruder unattended.
Make sure to maintain the air supply.
drive unit and deposit the hand extruder as
shown in the illustration below.
Page 11/20