American Standard Chandler Americast 7182.803 Lembar Spesifikasi - Halaman 3

Jelajahi secara online atau unduh pdf Lembar Spesifikasi untuk Perabotan Dalam Ruangan American Standard Chandler Americast 7182.803. American Standard Chandler Americast 7182.803 7 halaman. Island sin

Halaman Cetak

UNDERCOUNTER MOUNTING FOR CHANDLER,

LAKELAND, PALISADE AND SILHOUETTE™

KITCHEN SINKS

MODELS 7145, 7162, 7163 STANDARD, 7103, 7172, 7173, 7179,

7182, 7183, 7185, 7196, 7255

Thank you for selecting American-Standard...the

benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

BEFORE YOU BEGIN...

Unpack new sink and inspect carefully for damage. Notify your American Standard distributor of any damage. Replace the

sink in its original packing carton to protect it until you are ready to begin installation.

The kit contains two types of cutouts. One cutout is for mounting the fitting on the countertop. The second is

NOTE

for mounting the fitting on the sink itself, below the countertop. Use the correct instructions for your application

Recommended Tools & Materials:

Silicone Sealant

Putty Knife

Pipe Wrench

Channel Locks

Phillips Screwdriver

Regular Screwdriver

Adjustable Wrench

INSTALLATION A — FITTINGS MOUNTED ON COUNTERTOP

Refer to American Standard roughing-in information for specific dimensions for each model.

1. Minimum countertop thickness is 19mm (3/4) for wood and 12mm (1/2") for marble and solid

CAUTION

surface material.

2. Prior to cutting countertop be sure that the fitting shank has sufficient length to attach the mounting nut

after the shank goes through both the countertop and sink deck. The deck is 3/8 (10mm) thick.

Below are the dimensions of each sink. Make sure this area is available to mount the sink. Unfold the template and refer

to the instructions below.

SINK CUTOUTS:

Locate and mark center lines of sink on countertop. Provide proper clearance under the countertop for the faucet

supply lines and the structural parts of the cabinet. Do not use permanent markers to indicate the center lines.

Cut the inner portion from the supplied template and discard.

Attach the outer portion of the template to the countertop using masking tape. Be sure that the center lines on

the template are aligned with those on the counter.

Installation

™

Instructions

Drill

Basin Wrench

Saber Saw

Tubing Cutter

Tape Measure

Hacksaw

Mineral Spirits

AMERICAST BRAND

SINKS

Certified to comply with ANSI A112.19.4.M

U.S. Patent No. 4,664,982

Other patents pending.

CAN/C.S.A. B-45

Observe local plumbing and building codes.

7 9 0 0 8 8 - 1 0 0 R E V . H