Domus MURO-15S-W-W Panduan Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sorotan Domus MURO-15S-W-W. Domus MURO-15S-W-W 4 halaman.
Halaman Cetak
1. Refit the Cable Anchorage
2. Fit main body onto the Backcover. Adjusting the light direction you desired, then tighten the screws.
3. Switch the main power on.
2X
6x27mm PA4x30mm
Ø88mm
Notes for electrician
• The LED lamp should be wired to its own light switch.
• Do not interconnect with other lights on the same switch.
• Earth connection must be required.
• Multiple Muro Fittings cannot be wired to a single switching point.
Understanding the controls
Adjusting the duration time:
The length of time that remains switched on after activation can be
adjusted from (10±5) seconds to (4±1) minutes. Rotating the TIME
knob + to - will reduce the duration time.
Note: Once the light has been triggered by the PIR sensor any
subsequent detection will start the timed period again from the
beginning.
2X
139mm
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600
OFF
|
Fax: 02 9554 9433
|
www.domuslighting.com
Installation Manual
6mm
30mm
ON
TIME
SENS
LUX
Control Knob
Ø88mm