American Standard Lakeland SERIES 7193 Petunjuk Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Perabotan Dalam Ruangan American Standard Lakeland SERIES 7193. American Standard Lakeland SERIES 7193 4 halaman. American standard kitchen sink installation instructions
Halaman CetakINSTRUCTIONS FOR COUNTERTOP MOUNTING.
AFTER THE CUTOUT IS DRAWN...
1
Perimeter
of sink
Drill a clearance hole inside the cutout line
as marked on the countertop.
2
Perimeter
of sink
Cut opening on cut line inside the perimeter of sink.
Note - Formica countertop installation only is
illustrated. Contact your countertop distributor for the
best method of cutting other materials such as marble,
hard synthetics, etc.
3
Countertop
Mount the faucet and drain assembly
on the sink or countertop following
the manufacturer's instructions.
7
A
7 9 1 3 9 3 - 1 0 0 R e v . A
Cutout
Cutout
Sink
Surface
B
Trap
Single Bowl
4
Masking
tape
outline
Remove sink and apply a masking tape
outline 1/8" outside traced outline as a
guide for application of silicone sealant.
5
Apply a generous portion of silicone sealant inside line traced
on countertop. Carefully lower sink into place and press down
firmly. Use guidelines for proper positioning. Using water to
dampen your finger, remove excess sealant for a smooth even
line. Apply additional sealant if necessary to provide a uniform
bead from the rim of sink to the masking tape line as shown.
Carefully remove tape. Dampen finger and run it slightly over
the sealant to remove any high spots. Use mineral spirits to
remove excess silicone from countertop and sink.
Masking
Tape
NOTE:
Silicone must be removed within 10 minutes of application
or a permanent residue may remain on the surfaces.
6
Countertop
Connect supply lines to faucet finger tight, and
carefully bend to engage with the supply
stops.Tighten connections to faucet for secure seal.
Connect drain assembly hand tight to check alignment.
It may be necessary to cut off part of the tailpiece (area
"A") or part of the horizontal leg of the trap (area "B").
Secure joint for watertight assembly.
2
Cutout
Sink
outline
1/8"
Silicone
Sink
Sealant
Sink
Surface