American Standard Retrospect Collection 0282.008 Spesifikasi
Jelajahi secara online atau unduh pdf Spesifikasi untuk Perabotan Dalam Ruangan American Standard Retrospect Collection 0282.008. American Standard Retrospect Collection 0282.008 1 halaman. American standard retrospect collection washstand specification sheet
Juga untuk American Standard Retrospect Collection 0282.008: Spesifikasi (1 halaman)
Halaman Cetak
RETROSPECT COLLECTION
• Retrospect Collection
reproduction of classic dry sink wood washstand
• Washstand/pedestal top with faucet holes on
8" (203mm) center
• Turned leg detailing with lower drawer storage in
White finish
• Select hardwood solids construction
• Right Height™ for greater comfort during use
• Part of design matched Retrospect Collection
Separate Components:
❏
0282.008 Washstand/Pedestal top
8" (203mm) centers
❏
9420.000 Washstand only
Nominal Dimensions with Sink:
27" x 19-3/4" x 36"
(686 x 502 x 914mm)
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.9M for Non-
Ceramic Fixtures
• CAN/CSA B45 Series
To Be Specified:
❏ Color: White only
❏ Recommended Faucet: 2373.701
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap: 752683-495
❏ P Trap Finish:
© 2008 AS America Inc.
®
WASHSTAND
pedestal top with period
®
RETROSPECT COLLECTION
®
FINISHED WALL
9"
(229mm)
1-3/4" DIA.
STD. DRAIN
OUTLET
FINISHED
WALL
7-1/4"
(184mm)
13-1/2"
(343mm)
7"
FINISHED
(178mm)
FLOOR
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND "P" TRAP ARE
SUGGESTED.
▼
ANCHOR SCREWS FOR LAVATORY AND PEDESTAL NOT INCLUDED.
- FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.9M.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
I24
WASHSTAND
FIRE CLAY/WOOD
13-3/4"
3 Holes
(349mm)
1-3/8" (35mm) Dia.
8"
(203mm)
27"
(686mm)
3/8" (10mm) DIA.
SINK ANCHOR
SCREW HOLES
ON 13-3/4" (349mm)
CENTERS
8"
(203mm)
1-1/4 O.D.
WASTE
*
24"
*
22"
(610mm)
(559mm)
1-1/4" O.D.
TAILPIECE
®
3-3/8"
(86mm)
15"
(381mm)
19-3/4"
(502mm)
SUPPLIES
AS REQ'D
36"
(914mm)
Revised 2/08