D3FY SPORTS Conqu3st Panduan Pemilik - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan paintball D3FY SPORTS Conqu3st. D3FY SPORTS Conqu3st 14 halaman.

using a squeegee or swab.

5.Wipe the Delrin Bolt and Striker with a clean cloth. Apply a

few drops of oil to the Striker O-ring (O-24).

Reassemble Rear Internals

1.Insert the Striker with the O-ring end facing in first and the

flat spot of the Striker facing down.

go in half way because of the Trigger Frame Sear. Apply

pressure behind the Striker with your thumb and at the same

time pull the trigger to release the Sear, this will allow the

Striker to insert all the way.

2.Insert the Striker Buffer so that it is flush with the Receiver

and insert the Striker Spring.

3.Insert the Velocity/Spring Guide into the Striker Spring, which

is connected to the Striker Plug and firmly tighten the Striker

Plug to the Receiver.

4.Insert the Delrin Bolt with the open face in first. Align the Bolt

Cocking Pin with the Striker hole, and push down on the

Pin to lock it in place.

Note:

upright, the Bolt Cocking Pin will not lock correctly.

Note:

the Striker will only

If the Striker hole is not aligned

MAINTAINING YOUR CONQU3ST PAINTBALL MARKER

WARNING

Before and after using the marker, make sure to fasten all

screws. Screws may become loose due to vibration caused by

firing the marker. Loose screws can cause parts to detach from

one another, which can be dangerous and cause injury.

To assure that the marker is assembled properly, follow the

schematic drawing or position parts in order during assembly.

Parts assembled improperly or using improper parts will/can

cause the marker to malfunction.

CUP SEAL REMOVAL

Disassemble Front Internals

Make sure all paintballs are removed from the marker and that

the air source is detached before attempting any maintenance

and/or repairs.

PART # and Description

(X-04) Front Plug

(I-06) Valve Spring

(I-07) Cup Seal/Valve Pin

(S-53) Front Plug Screw