Da-Lite 20897F Petunjuk Manual - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Layar Proyeksi Da-Lite 20897F. Da-Lite 20897F 6 halaman.

Disclaimer

Legrand AV Inc. and its affiliated companies and subsidiaries

(collectively, "Legrand AV"), intend to make this manual accurate

and complete. However, Legrand AV makes no claim that the

information contained herein covers all details, conditions or

variations, nor does it provide for every possible contingency in

connection with the installation or use of the products described

herein. The content herein is subject to change without notice or

obligation of any kind. To the maximum extent permitted by

applicable law, Legrand AV makes no representation or warranty,

expressed or implied, regarding the information contained

herein. Furthermore, Legrand AV assumes no responsibility for

accuracy, completeness or sufficiency of the information

contained in this document.

Da-Lite® is a registered trademark of Legrand AV.

When using your video equipment, basic safety precautions

should always be followed, including the following:

Read and understand all instructions before using.

Failure to provide adequate structural strength for this

component can result in serious personal injury or damage to

equipment! It is the installer's responsibility to make sure the

structure to which this component is attached can support the

weight of all equipment. Reinforce the structure as required

before installing the component.

Use this projection screen only for its intended use as described

in these instructions. Do not use attachments not

recommended by the manufacturer.

Save These Instructions

Pre-Installation

1. Carefully unpack case from shipping carton. DO NOT unpack

fabric and roller assembly yet.

2. Make sure to recheck measurement of case for proper

installation clearance.

3. Remove any protective foam or tape from case.

1. Hang case and attach to support structure with bolts.

See suggested methods of installation on page 3.

NOTE: Carriage bolts can be installed anywhere along the

length of the case. The head of the carriage bolt slides into

the variable-position mounting channel. It is recommended

that the center is supported on cases longer than 7 feet.

2. Tighten bolts until trim flange is flush with ceiling.

NOTE: For proper operation, screen assembly must be

level after installation.