American Standard 3468 Panduan Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Toilet American Standard 3468. American Standard 3468 13 halaman.

American Standard 3468 Panduan Petunjuk Instalasi
10
TOP
CRITICAL LEVEL
MARK ("C.L.")
MUST BE
1" ABOVE
OVERFLOW PIPE
FLOAT
CUP
FILL
VALVE
VALVE
BODY
ADJUSTABLE
HEIGHT
LOCK NUT
CONE WASHER
COUPLING NUT
(HAND TIGHT ONLY)
12

CARE AND CLEANING

When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry with a soft cloth. Avoid detergents,
disinfectants, or cleaning products in aerosol cans. NEVER use abrasive scouring powders or abrasive pads on your toilet seat. Some
bathroom chemicals and cosmetics may damage the seat's finish.
!
WARNING:
Do not use in-tank cleaners. Products containing chlorine (calcium hypochlorite) can seriously damage fittings in the
tank. This damage can cause leakage and property damage.
American Standard shall not be responsible or liable for any tank fitting damage caused by the use of cleaners containing
chlorine (calcium hypochlorite).
Repair parts are determined by toilet tank number which can be found marked inside tank.
NOTE: "XXX" represents color or trim finish options. Specify when ordering.
PART NO.
735131-400-XXX
738565-435.0070A
738565-436.0070A
738565-437.0070A
738570-1030A
7381009-0070A
7381007-400.0070A
7381007-401.0070A
7381007-406.0070A
7381007-412.0070A
730512-0070A
7381008-400.0070A
047192-XXX0A
738171-XXX0A
034783-XXX0A
ARM
REFILL
NIPPLE
TUBE
TANK
LEVER
Fig. 10A
"S"
CLIP
FLUSH
VALVE
WATER LEVEL
ADJUSTMENT
ROD
FLAPPER
SHANK
WASHER
THREADED
SHANK
PARTS FOR WATER
CONNECTION
(SEE STEP 9)
Diagram 1

REPAIR PARTS LIST

DESCRIPTION
TANK COVER
FLUIDMASTER 400A VALVE
FLUIDMASTER 400A VALVE
FLUIDMASTER 400A VALVE
FLUIDMASTER REFILL TUBE
FLUIDMASTER REFILL CLIP
FLUIDMASTER FLUSH VALVE
FLUIDMASTER FLUSH VALVE
FLUIDMASTER FLUSH VALVE
FLUIDMASTER FLUSH VALVE
TANK COUPLING KIT #232
FLUIDMASTER FLAPPER ASSEMBLY
TRIP LEVER ASSEMBLY LH
TRIP LEVER ASSEMBLY RH
BOLT CAP KIT #128
ADJUSTMENTS
a. Adjust water level. Water level
should be adjusted to level indicated
on tank by adjusting float cup.
See Step 11 for water level adjustment
method
b. If bowl fails to siphon, an adjustment
may be required with the lift chain.
Simply remove the bead chain from
the retainment clip (see Fig. 10A)
and take up slack on the chain, and
reinsert on lift rod. Make sure the
chain is not too taught.
- 3 -
11
Turn on water supply.
Submerge the FLOAT CUP
under the water for 30
seconds. Adjust the water to
desired level by turning
WATER LEVEL ADJUSTMENT
ROD and moving FLOAT CUP
up or down.
TANK NUMBER
7 30 1 17 0 - 1 0 0 R e v. D