Da-Lite ViewShare Tensioned Advantage Electrol Retrofit Buku Instruksi - Halaman 8
Jelajahi secara online atau unduh pdf Buku Instruksi untuk Layar Proyeksi Da-Lite ViewShare Tensioned Advantage Electrol Retrofit. Da-Lite ViewShare Tensioned Advantage Electrol Retrofit 20 halaman.
Halaman CetakInstallation of ViewShare Screen and Roller Assembly
NOTE: The ViewShare screen and roller assembly, which
includes brackets and arms, must be installed as a complete unit.
Do not attempt to disassemble these components during
installation.
1.
Remove two 1/4 – 20 nuts from pin end and motor end mounting
brackets on the ViewShare screen and roller assembly shipping
board (Figure 16).
NOTE: If you transferred you existing motor, the motor end nuts
have already been removed.
2. Remove screws from both L-brackets that hold the slat in place
and carefully allow the slat to rest behind the ViewShare screen
and roller assembly (Figure 16).
NOTE: If you transferred your existing motor, the L-brackets have
already been removed.
3. Install ViewShare screen and roller assembly by placing the unit
inside of case and secure motor end bracket by aligning bracket
holes with bolts. Secure with two 1/4 – 20 nuts (Figure 17).
4. After the motor end is completed in Step 3, secure pin end by
aligning bracket holes with bolts. Secure with two 1/4 – 20 nuts
(Figure 17).
5. Once both ends are secured, ensure that the mounting brackets
are parallel with both ends of the case (Figure 17).
NOTE: Brackets must be parallel with the case to ensure proper
alignment of arms. Misalignment may cause damage to screen
surface and arm assemblies.
8
Shipping
L-Bracket
Motor End
1/4 – 20 Nuts
Bracket Parallel
to End
1/4 – 20 Nuts
Figure 16
Pin End
1/4 – 20 Nuts
Bracket Parallel
to End
Figure 17