Da-Lite IDEA 22516 Panduan Petunjuk Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Proyektor Da-Lite IDEA 22516. Da-Lite IDEA 22516 12 halaman. Idea interactive rear projector cart

Halaman Cetak
22516/22951
IDEA™ Screen Installation
1.
Slide inner top frame (E) into outer top frame (F), making
sure screws on inner frame are aligned with holes on outer
top frame. (See Figure 7)
(E)
Figure 7
CAUTION:
Do NOT touch back of IDEA™ screen during
installation or projection surface may be damaged!
2.
Carefully slide IDEA™ screen into cart, inserting it into the
grooves at the back of the column extenders (J and K) and
making sure it is fully seated in the top groove of the screen
tray and cross assembly (D). (See Figure 8)
3.
While holding the screen in place, set inner and outer top
frames (E and F) on top of screen. (See Figure 8)
2
Figure 8
4.
Use four #10-24 x 3/8" Phillips machine pan screws (BB) to
secure outer top frame (F) to column extenders (J and K).
(See Figure 9)
5.
Turn seven screws pre-installed on inner top frame (E)
counter-clockwise until screen is tightly secured. (See
Figure 9)
8
(F)
3
2
CAUTION:
Do NOT over-tighten screws or screen may be
damaged!
(BB) x 4
5
6
Figure 9

Projector Installation

CAUTION:
Make sure knobs (R) are tightened prior to
installing projector to projector boom arm! Boom arm may fall
off if knobs are not secured.
1.
Attach SSMU interface bracket to projector following SSMU
installation instructions.
2.
Lower projector and attached SSMU interface onto RSM
plate on projector boom arm. (See Figure 10)
3.
Slide projector with SSMU onto mounting slots in RSM plate
until mounting buttons are seated against the back of
mounting slots. (See Figure 10)
4.
Move locking lever on RSM to "locked" position. (See Figure
10)
5.
Insert key into lock and turn to secure projector to mount.
5
4
Figure 10
Installation Instructions
(rear view)
3
2