American Standard 2390 Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Bak Mandi Air Panas American Standard 2390. American Standard 2390 4 halaman. American standard princeton bath installation instructions

Halaman Cetak

American Standard 2390 Petunjuk Instalasi

DRAIN INSTALLATION

Remove Lift and Turn Stopper and Tailpiece Assembly from box and check that all

parts are included. Remove Lift and Turn Stopper Assembly from Tailpiece by setting

Stopper to closed position, and turning Stopper Knob counter-clockwise.

(Re-install Stopper after Drain installation is completed.)

Apply plumbers putty around drain hole and pipe thread compound on threaded

end of tailpiece.

Set Tailpiece in drain hole. (Lift and Turn Stopper Assembly should be removed,

and reinstalled after tub installation is completed.)

From underside of tub: Place Rubber Wedge Seal on Tailpiece, small end toward tub,

and center in hole, place Brass Washer on Tailpiece, and thread on Locking Nut, flange

side first. Tighten Locking Nut to obtain a uniform seal between Wedge Seal

and hole in tub.

DO NOT OVERTIGHTEN!

Final hook up to tub waste can be made using either internal threads in Tailpiece

(1-1/2 tubing 1-1/2—28 thd.), or external threads on Tailpiece (1-1/2—11-1/2 NPSM)

for appropriate tub fittings.

TURN TO

REMOVE

STOPPER IN

CLOSED POSITION

(UNSCREW STOPPER ONCE IN

CLOSED POSITION TO REMOVE)

SET

TAILPIECE

791174-100 Rev. G

STOPPER

KNOB

STOPPER

ASSEMBLY

TAILPIECE

RUBBER

DRAIN SEAL

BRASS DRAIN

WASHER

BRASS

STOPPER IN

DRAIN NUT

OPEN POSITION

LIFT AND TURN

STOPPER ASSEMBLY

APPLY PIPE JOINT

COMPOUND TO

THREADS

APPLY PLUMBERS

PUTTY

ASSEMBLE AND

TIGHTEN

INSTALLATION

Position bathtub within the recess, check level, front to back, side to side. Also

check drain clearance hole in sub floor. To secure the tub to wood studs, use

roofing nails immediately above the flange of the tub.

To secure the tub to steel studs, use drywall screws and flat washers. (See Step 4)

Caution: Take Extra Care When Driving Nails or Screws To Avoid Damaging

The Tub. The tile or similar finished floor will be butted against the bottom of the

tub apron also holding the tub in place.

NOTE: Warranty will be voided if the drain is installed after the tub has been

set in place.

NAIL

DRYWALL

SCREW

EVERY STUD

Below is shown typical cross sections of the tub rim

showing typical wall constructions.

STUD

SHIM

DRY WALL

TILE

ROOFING NAIL

SEALANT

TUB

2 x 4 WOOD

STRINGER

FULL LENGTH

WOOD STUDS

UNDERLAYMENT

FINISHED TILE FLOOR

SUB FLOOR

STEEL