Daan Tech BOEM Panduan Memulai Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Mesin pencuci piring Daan Tech BOEM. Daan Tech BOEM 14 halaman.
Halaman Cetak
1 | QuiCK Set-up Guide
1 | S
Cope of appliCation and plaCe of uSe
1.1 | Scope of application
Bob might be humid inside when you receive it. In fact, every Bob has been tested before shipping
(empty cycle with clear water). Therefore, there might still be some traces of residual water.
Warning: Bob's inclination shall not exceed 2° in order to avoid possible flooding.
Precautions against frost:
Bob shall not be stored in a place with a temperature lower than 0°C. If such a situation could
occur, ensure that Bob has been drained using the draining program (
inlet water hose.
1.2 | Place of use
You can place Bob anywhere you want, it is the smallest dishwasher ever!
On top of a shelf
The shelf should withstand a weight of 25 kg (55,1 lbs) (weight of Bob + water + dishes).
On a work surface
The provided water outlet's length is 1m50.
Place Bob on a water-resistant surface to avoid stains. When filling Bob's water tank or taking
out dishes, drops of water may end up on the work surface.
Below the sink
During a cycle, please make sure that nothing hinders the automatic opening of the door at
the completion of the program.
Warning : In the long run, the steam released during the opening of the door may damage
wooden surfaces.
2
Bob's 4 feet can be adjusted up to
+1cm (+0,4in) to ensure that it is in
a perfectly horizontal position.
)
3 options
2 | S
-
et
2.1 | Water inlet
1
Plug the water inlet hose
on one side to the back of Bob and on the other
side to a water inlet via a 19 mm threaded end
(3/4 inch) and make sure the connection is
firmly tightened.
and remove the
WARNING: Close the water supply tap
after each use of Bob.
Warning: Do not block the water inlet of
the water tank. This must always remain
free.
2.2 | Water outlet
Plug the water drain hose to the back of Bob.
Warning: To prevent leaks, please use a screwdriver to fix the
water outlet.
C
up and
onneCtionS
2 available options
Using Bob as an autonomous free-standing
dishwasher thanks to its built-in water tank. In
this case, no water inlet hose is needed! Please
use carafe to quickly fill the water tank! Bob can
be filled with either cold or hot water up to 60°C.
Please always fill the water tank before use (4L
capacity) with the door open, until you hear the
signal sound that indicates that the tank is full.
2
Do not overfill the tank! If you fill in
more than the water tank capacity (4 L),
the excess water will escape into Bob's
main interior.
3