Daavlin 7 Series Panduan Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Lentera Daavlin 7 Series. Daavlin 7 Series 13 halaman. Integrated dosimetry with link control
Juga untuk Daavlin 7 Series: Panduan Instalasi (2 halaman)

Halaman Cetak

Before each treatment, the Link Controller will ask you about the condition of your skin since your prior

treatment. It will use this information to calculate your next dose. It is normal to experience some slight

"pinkness" about 8 – 12 hours after a treatment, which is typically gone before it is time for your next treatment.

Operating the Home Link

Setting up a Treatment

1. Touch the screen to awaken the unit and open the Logo screen. Touch the Logo screen. The Lock

screen will appear (if enabled).

2. Enter in your Key Code using onscreen keypad. Unless you have changed it, the factory preset Key

Code will be 0007.

3. Once the key code is entered, the Treatment screen will appear. The first time you use the device, your

first dose will automatically appear, based on your doctor's prescription. After your first treatment, this

screen will display the next scheduled treatment, but will also ask if you experienced any pain or redness

after your last treatment.

according to your prescription.

Were you in pain or red after your last treatment?

•

4. Once you have highlighted your response, tap the Enter key.

5. The Treatment Confirmation screen will appear and will display the dose and an estimated time for your

treatment. If changes need to be made, press the back arrow.

6. Put on your goggles and position yourself 9 inches from the front of the device.

7. Tap the Enter key

turn on.

8. The screen will display your progress and the lamps will shut off when the treatment is over. If you need

to pause in the middle of the treatment, tap the Pause button.

9. You have now treated one half of your body. To treat your entire body, you will need to repeat the same

dose on the other half. To repeat the same dose, touch the Repeat button.

Special Notes

If power goes off during a treatment, the system will remember how much of the treatment has elapsed.

•

When power is restored, your device provides an option to resume interrupted treatment.

MANU0140

Rev. 0

2/2019

Control System

Based on your response, the Link Controller will adjust your treatment

No, or less than 24 hours ( "Not at all, or it was gone in less than 24 hours" )

24 – 48 hours ( "I was in pain or red for 24-48 hours after the treatment" )

More than 48 hours ( "I was in pain or red for more than 48 hours" )

Still red / pain

( "I am currently still red or have pain" )

Note: Selection of the "Still red / pain" option will instruct the user to skip a treatment, and will

lock the device until one treatment has been skipped as an intentional safety measure to prevent

treating the skin until the erythema (redness) has resolved.

to begin the treatment. A 3 second countdown will begin, and then the lamps will

To cancel press X.

Tap the Play button to resume.