EKHO EK-WL8-AU Panduan Memulai Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Aksesori EKHO EK-WL8-AU. EKHO EK-WL8-AU 7 halaman. Wireless heat sensor
Juga untuk EKHO EK-WL8-AU: Manual (6 halaman)

EKHO EK-WL8-AU Panduan Memulai Cepat
STFV.425238.032-AU-UM rev. 16
PROGRAMMING
The "Prog." button on the device is used for initializing the device on to the system.
Please refer to the translator manual for full instructions on how to add a device to
the system. The device can also be initialized using the "Ekho Configuration" soft-
ware.

INSTALLATION

In order to install the device, the mounting base
should be fixed to the ceiling, the sensor can then be
inserted into the base by rotating the sensor until it
clips into the base
Preferably, the device should be installed away from
metallic objects, doors, and power lines, as they can
cause the communication distance to drop. It is also
important to avoid installing the device near electron-
ics and computer equipment in order to protect them
from potential electromagnetic interference.
INDICATION
The device has a LED which indicates its state according to the following:
LED indication
No indication or green flashes
Yellow flashes every 4 seconds
Red flashes every 2 seconds
When the device is powered up, an automatic calibration process will begin, this
lasts around one minute and is indicated with a red flashing LED.
EK-WL8-OH/AU
WIRELESS MULTI-SENSOR SENSOR
10.08.2020
Device's state
Standby mode
Fault state – low battery or malfunctioning
smoke or thermal sensor
Fire alarm
Page 3 from 7