Ekinex EK-GD1-DL-4-HV Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Dimmer Ekinex EK-GD1-DL-4-HV. Ekinex EK-GD1-DL-4-HV 6 halaman. Dali 2 90-230 vac 4-channels phase cut dimmers

Halaman Cetak
Protections
The device is equipped with the following protections:
• OVP Input voltage peak protection
• RVP Overcurrent protection with 3 A non-resettable
fuse
• OCP Output open circuit protection
Control, signaling and connection elements
The device is equipped with a spring clamp for connecting
the output loads on 4 channels and the 90 - 230 Vac input
power supply (4). There is also a signaling LED for the
presence of the power supply (2), a button and LED for
each channel (3), for local on / off test also in case of DALI
bus absence and finally a spring terminal for connection
of the DALI line (1).
1
2
Power
3
EK-GD1-DL-4-HV
Dimmer Dali 90-230V~ 4 canali
Out: 4x 200W
1
2
4
EK-GD1-DL-4-HV
Nr.
Label
1
-
DALI bus - pole 1 and 2 spring clamp
2
Power
Signalling LED
3
x
LED and channel x (x = 1,2,3,4) button
4
-
Power supply and loads clamps
The terminals for power supply and loads follow the dia-
1
2
3
4
5
gram in the table:
L
N
L
N
Label
x
Channel x (x=1,2,3,4) AC output - Live
COM
Channel x (x=1,2,3,4) AC output - Neutral
N
AC input - Neutral
L
AC input - Live
3
4
Connection
6
7
8
9
10
11
1
2
3
Connection
Mounting
The device has degree of protection IP00 (IP20 inside a
wall-mounting box or electrical panel), and are therefore
suitable for use in dry interior rooms. The mounting must
be performed on a profiled rail according to EN 60715
inside electrical distribution panels and cabinets.
To disassemble the device, to have first to disconnect the
inputs, outputs and power supply.
When assembling, make sure to leave only the front pa-
nel accessible; all other sides must not be accessible.
Proceed as follows:
• with the aid of a tool bring the locking device in the fully
lowered position (a);
• place the upper edge of the rear inner profile on the
upper edge of the rail (b);
• rotate the device towards the rail (c);
• push the locking device upward until it stops (d).
a
c
To remove the device, be sure that inputs, outputs, and
the input power supply have been disconnected. Then
use a screwdriver to slide down the locking device and
remove the device from the rail.
12
i
Note. When mounting the device in boards and ca-
binets it shall be provided the necessary ventilation
so that the temperature can be kept within the ope-
rating range of the device.

Setup and installation

The steps to setup the device are as follows:
4
1.
Connect the loads to the
of the device
2.
Connect the DALI bus to the corresponding terminals
of the device
3.
Connect the 90 - 230 Vac power supply to the L, N
input terminals of the device
2
b
d
-x and COM terminals