American Technologies Network Night Scout Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Teropong American Technologies Network Night Scout. American Technologies Network Night Scout 8 halaman. Night vision binocular night scout

Halaman Cetak

the Ir-450 illuminator has a control panel with

two buttons. to switch the Ir illuminator on/off

press "+" and "-" buttons simultaneously. When

the Ir illuminator is switched on you can see

the green LeD lit on the back side of Ir450. By

pushing the buttons "+" and "-" you may adjust

the Ir brightness.

the Ir beam is focusable to change the field

of coverage. to change the beam width slightly

turn the Ir lens. You may need adjust the focus-

ing of the Ir beam to change the field of cover-

age. Do it by slightly rotating the Ir lens. the

windage and elevation screws help adjust the

direction of the Ir beam from the Ir450 in order

to focus on the scene observed in the viewfinder of your nvD. Use the included allen wrench

to rotate the adjusting screws until the Ir beam is centered. please remember the adjustments

should be performed under night light conditions only.

You can change the position of the Ir control panel to meet your needs. the wrench that is

included in the set, is used to loosen the nut located on the body of the Ir. rotate the Ir to the

desired position. tighten the nut with the wrench to secure the new position.

operATion

• Take the binoculars out of the case.

• Install the batteries into the housing with the polarity order as shown on the binoculars. Bat-

tery type: 3 volt Lithium, #Cr123a

• Press the button marked -/O to turn unit on with the protective lens covers still attached to

the lenses. Do not turn unit on in the daytime without the protective lens caps on. You

should see a green glow in the eyepieces.

• Observe the scene, and adjust the diopters for the optimal image clarity.

• You may now enter a dark environment or simply shut the lights off in order to darken the

room.

• Next, remove the lens caps/daylight filters and observe the scene. You should readjust the

diopters for maximum clarity. remember the focus range of the binocular is 20' to infinity.

• The unit will turn on and off automatically when you bring it to or take away from your eyes.

this is done by activating the proximity sensor. to activate the proximity sensor push the dig-

ital control marked "a". You will notice the green LeD change to red when the sensor is on.

• In order to assure the proper functioning of the proximity sensor, make sure that the protective

glass surface of the sensor is always clean. adjust the digital features as needed.

• To increase battery life the LED diodes will go off after 10 seconds.

• Take your time learning about your "smart" binoculars. It will take practice to properly use the

device. as you use these binoculars you will be able to improve your speed of focusing, as

well as sharpness of image.

• Have fun and enjoy.

cleAning The eyepiece

You may need to clean the eyepiece of the night Scout from time to time in order to guarantee

top performance. When you receive your night Scout you should check for dust on the eye-

piece of the unit. First you will need to remove the eyepiece. to remove the eyepiece you will

need to initially loosen 2 set screws that can be found on the base. then unscrew the eyepiece

counter-clockwise to remove it.

NOTE: You do not have to remove the set screws completely, they are very small and easy to

misplace.

Ir Brightness adjustment

Battery

housing

Screwing-on Cap

elevation

Ir Focusing

Windage