American Turbine SD203 Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Perahu American Turbine SD203. American Turbine SD203 10 halaman. Super duty jet 203mm axial flow

but the most common reasons for reduced engine power are:
1. Throttle: Check that the throttle is opening fully.
2. Fuel: The fuel supply must be adequate for the engine size. Racing boats frequently have a fuel pressure gauge which is,
with the tachometer, probably the most important engine instrument. Sufficient fuel must be reaching the engine.
3. Air to the engine: The carburetor must be getting its full quota of cool air. If the engine has to work to get adequate air, and if
it is hot air, this will reduce power.
4. Ignition spark: Be satisfied the ignition system is operating properly. A problem here is usually indicated by a rough running
or missing engine.
5. Exhaust: Check for a free flowing exhaust system. Some silencers can become blocked, rubber hoses disintegrate internally,
or there is excessive water injection. Such things can cause excessive back pressure and reduce power.
Provided your engine is getting its full quota of air and fuel, and is getting enough spark and at the right time, the engine
will usually be OK, and maximum RPM's will result. However if the RPM's are down and you believe the tachometer, look
for an engine problem. The hull, engine, and jet unit are the three main areas to look at when your performance is down.
D. Excessive noise.
This can often be a concern even if there is not a reduction in performance. The most common causes of noise are:
1. Cavitation: The jet unit is starved for water, and usually sounds like a rattle or a can of loose bolts in the back of the boat.
Most likely a blocked intake grate.
2. Moan or whine: The jet unit can exhibit some "turbine whine" not unlike a turbocharger noise but you will know what is usual
with your boat. However, if you have a new more obvious moan/whine, especially if it is a very low frequency grumble at idle,
that increases with engine RPM's then it is likely to be a rough/worn/water damaged thrust bearing. If water has gotten into the
bearing, it is usually as a result of a flooded bilge at some time on a warm bearing, then water can be sucked in as it cools.
3. Periodic vibration: Often at specific RPM's and disappearing at other throttle openings is probably a torsional vibration emanating
most likely from the universal joints on the drive shaft.

WARRANTY REGISTRATION

1. Owners Name _______________________________________ Phone Number _______________________________
2. Address ___________________________________________________________ City ___________________________
3. State _________ ZIP _________________ E-mail ________________________________________________________
4. Dealer Name ___________________________________________ Dealer Phone Number ________________________
5. Jet Drive Model _____________________________________ Serial Number ________________
6. Engine Make _______________________________________ Size ______________________
7. Boat Make _______________________________ Model _______________________________________ Length ______
8. Primary Use - Pleasure-----Commercial------Freshwater-------Saltwater
9. Pre-Delivery Inspection Completed ______ Yes ______ No Date ___________ Inspection must be completed by Dealer
10. Date of Sale ___________________ Date Put in Service _____________________
11. Owner Signature ______________________________________________________________ Date ________________
12. Dealer Signature ______________________________________________________________ Date ________________
This Warranty Card must be completed and mailed to American Turbine. The jet drive warranty is void if registration is not mailed within 15 days of date of sale.
AMERICAN TURBINE
3692 RIVERSIDE DR.
CLARKSTON, WA 99403
PHONE: (509) 243-5387
FAX: (509) 243-5391
INTERNET: WWW.AMERICANTURBINE.COM
AMERICAN TURBINE
3692 RIVERSIDE DR.
CLARKSTON, WA 99403