AMERICH TCS Panduan Operator - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Operator untuk Perlengkapan Kamar Mandi AMERICH TCS. AMERICH TCS 2 halaman. Thermal comfort system

Halaman Cetak

IMPORTANT SAFETY INSTRUCTIONS:

Warning: Whirlpool bathtubs utilize acrylic and fiberglass materials (which are inherently slippery surfaces), electricity, water, air pressure and suction. The following basic

safety precautions should always be followed when using your bathtub.

READ AND SAVE THESE INSTRUCTIONS

ELECTRICAL REQUIREMENTS

Manufacturer recommends a dedicated 20 amp circuit breaker for each

power cord supplied on your whirlpool bathtub. WARNING - When

using electrical products, basic precautions should always be followed,

including the following:

1. DANGER: Risk of electric shock. Connect only to a supply circuit

protected by a Class A ground-fault circuit-interrupter (GFCI). Test

on a routine basis.

2. Grounding is required. The unit should be installed by a qualified

service representative and grounded.

3. (For built-in and custom units) install to permit access for servicing.

4. Supply 110 Volt electrical outlet. This circuit must be protected by a

ground fault circuit interrupter (GFCI.)

thermal comfort system

GFCI

outlet

controll box

pertaining to a risk of fire, electric shock, or injury to persons

controll pad

tub

operating instructions

T h e r m a l C o m f o r t S y s t e m ( T C S ) ®

5. Plug supply cord(s) into electrical outlet.

6. To test the GFCI, do the following:

a. Push the test button;

b. Check to see that power has been interrupted;

c. Push the reset button;

d. Check to see that power has been restored.

If the GFCI does not operate properly during the test, there is a ground

current flowing indicating the risk of electric shock. Do not use this

unit. Disconnect the unit and have the problem corrected by a qualified

service representative before using.

Refer to Operating Instructions for system operations and wiring

diagrams.

System Temperature

1st Press: Press and hold to power on. TCS will heat to 90º.

2nd Press: TCS heats to 104º.

3rd Press: TCS turns off.

*Thermal Comfort System requires 10-15 minutes to reach heat level.

Auto-Off Function

Thermal Comfort System has a 30 minute auto-off function that allows you

to safely enjoy a bathing system like no other. The TCS is eco-friendly and

consumes less energy than a common 60 watt light bulb.

PERFORMANCE

US CA

E87277