astra telematics AT110 Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk GPS astra telematics AT110. astra telematics AT110 4 halaman.

Revision 1.1

4. Connect the CB110 3-way Power & Ignition Cable

a. Plug the CB110 cable into the small white socket on the front panel of the AT110

(note: the key on the CB110 plug matches the notch at the top of the socket)

b. Connect the power and ignition (if required) as outlined below:

CB110 cable

c. Connect the IGNITION wire to an ignition switched 12/24V signal (i.e. something that

only goes live when the vehicle ignition is ON). This is not necessary when using

IGNM=3, in this mode engine running is detected from external voltage

5. Fit the SIM:

a. Slide the SIM into the AT110 slot with the notched corner to the left-hand side, as

below:

b. Ensure the SIM is pushed in all the way

c. Note that the AT110 will now power up

d. Both LEDs will illuminate

e. You should see text on your TeraTerm screen

f. To remove the SIM, push it inwards, and it will spring out

6. Configure Settings

a. Once the device is running and you can see output text scrolling in TeraTerm, you are

ready to configure the device by typing or pasting commands into the TeraTerm

window (note: these commands can also be sent by SMS).

b. Configure GSM/GPRS network operator APN settings to suit your SIM using the

following commands:

$APAD,<apn_address>

$APUN,<apn_username>

$APPW,<apn_password>

if you don't know the appropriate APN settings for the network operator you are

using, please ask your SIM provider. In some cases, you may be able to find the

appropriate settings on this webpage:

7 - 32V

GND

red

black

http://www.taniwha.org.uk/gprs.html

IGNITION

white