Doorentryonline SR2 Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembaca Kartu Doorentryonline SR2. Doorentryonline SR2 12 halaman. Proximity & wiegand card reader with remote control
Halaman Cetak
Delete User Cards Via the Remote Control
Programming Step
1. Enter Program Mode
2. Delete Card: By read card
OR
3. Delete Card: Select Specific ID
OR
4. Delete Card: by Card Number
3. Exit Program Mode
Delete All Users Via the Remote Control
Programming Step
1. Enter Program Mode
2. Delete All User Cards
3. Exit Program Mode
Set Relay Configuration Via the Remote Control
The relay configuration sets the behaviour of the output relay on activation
Programming Step
1. Enter Program Mode
2. Pulse Mode
OR
3. Latch Mode
4. Exit Program Mode
Set Strike-out Alarm Via the Remote Control
The strike-out alarm will engage after 10 failed card attempts. Default setting is OFF. The strike-out alarm can
be set to deny access for 10 minutes after engaging or it can be set to disengage only after presenting a valid
user card or Master code
Programming Step
1. Enter Program Mode
2. Strike-Out OFF
OR
3. Strike-Out ON
OR
4. Strike-Out ON (Alarm)
Set alarm time
5. Exit Program Mode
Remote Control Operation
* (Master Code) #
2 (Present Card) #
Repeat Step 2 for additional user cards before pressing the
#
2 (Enter user ID number) #
The user ID is any number from 1-998
2 (Input the 8/10 digits Card number) #
*
Remote Control Operation
* (Master Code) #
2 (Master Code) #
*
Remote Control Operation
* (Master Code) #
3 (1-99) #
The relay time is 1-99 seconds. (1 is 50mS.) Default is 5
seconds
3 0 #
Sets the relay to ON/OFF Latch mode
*
Remote Control Operation
* (Master Code) #
6 0 # (factory default)
6 1 # Access will be denied for 10 minutes
6 2 #
5 (0 - 30) # factory default is 1 minute
Enter Master code # or valid user card to silence
*