DoorHan PCB-SH Manual Petunjuk Pemrograman - Halaman 12
Jelajahi secara online atau unduh pdf Manual Petunjuk Pemrograman untuk Pembuka Gerbang DoorHan PCB-SH. DoorHan PCB-SH 14 halaman. Control board
Juga untuk DoorHan PCB-SH: Manual Petunjuk Pemrograman (16 halaman), Manual Petunjuk Pemrograman (12 halaman)
Halaman Cetak
2.2. CONFIGURING AUTOMATIC CLOSING ACTUATOR
Set the operator operation mode with automatic closing (mode 5). Press and hold down the P button, the Program indicator
will
illuminate continuously and in three seconds it will go out. Take the desired time for an automatic closing timer and again
press the P button (maximum automatic closing time is 5 min).
NOTE:
•
The door automatic closing function operates only in the operation mode 5.
•
IIf setting of the pause time before automatic closing has not being carried out, then in the preset operation mode with
•
automatic closing the operator will be automatically closed in 30 seconds.
3. PROGRAMMING OF REMOTE CONTROL PANELS
3.1. RECEIVER MEMORY CLEARING.
After power supply is switched on, press and hold down the panel programming button«R»; the «
illuminate solid red, after 10 seconds the indicator will go out and light up for one second to confirm that the panels have
been erased from the memory. Release the panel programming button «R»
3.2. RECORDING OF DOORHAN PANELS IN THE RECEIVER.
For panel programming press and hold down the «R» button for 3 seconds. The «
red. Release the «R» button. Select a button on the remote control panel, with the help of which you will control the operator
operation later on. Press twice the selected button, and the red indicator «
has been programmed in the receiver.
NOTE:
The «
» indicator will flash three times when there is the receiver memory overflow
Remote
(maximum number of panels in the receiver memory – 60 pc.).
For programming several panels repeat the programming procedure for each panel
3.3. REMOTE PROGRAMMING OF DOORHAN PANELS.
It is necessary to perform items 1-4 within the five seconds interval:
1. Press and hold down button 2 (see Figure 1) of the programmed panel.
2. Press and hold down button 1, not releasing the pressed button 2.
3. Release all pressed buttons.
4. Press the programmed panel button; the receiver will enter the panel programming mode (the «
illuminate continuously).
5. Press twice a button on the new panel, with the help of which you will control the operator operation later on. The
«
» indicator will flash once to confirm that the panel code has been programmed in the receiver.
Remote
NOTE:
- It is necessary to perform the panel programming within the working range of the receiver for the electric operator
control board.
- The button number can be determined according to dots on the panel body.
1
3
4
2
12
3
2
1
4
PROGRAMMING OF CONTROL PANELS
» indicator will illuminate solid
Remote
» will flash once to confirm that the panel code
Remote
1
2
1
» indicator will
Remote
» indicator will
Remote
2