DoorHan SHAFT-30 Panduan Instalasi dan Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pembuka Gerbang DoorHan SHAFT-30. DoorHan SHAFT-30 12 halaman. Ip65/60 ip65
Juga untuk DoorHan SHAFT-30: Panduan Instalasi (8 halaman), Manual (12 halaman)
Halaman Cetak
6. MANUAL CONTROL OF OPERATOR
6.1. CONTROL WITH RELEASE
If required the operator can be released with the handle of the built-in release.
To open and close the door manually, turn the release lever up to the stop. Power supply to the operator will be
disconnected.
To return in automatic control mode, turn the release lever backwards up to the stop. Power supply to the operator will
be restored.
6.2. CONTROL WITH CHAIN
The Shaft-30 electric operator is equipped with a manual chain reducer, which is used for emergency lifting/lowering of the
door in case of a power cut. Pull the chain to operate the door in case of emergency.
WARNING! Intensive regular use of the manual chain reducer is forbidden.
Use it in case of emergency only.
WARNING! Using the manual chain reducer, make sure, that the chain links are not deformed or dirty. Otherwise the
reducer can be jammed.
Lengthen or shorten the chain so that when assembled it hangs 50–150 cm above the floor. It is recommended to fix the lower
part of the chain which can be a hindrance to people and equipment. Place the warning labels, showing closing and opening
direction, in plain view.
WARNING! Use the chain only in case of emergency; otherwise
the reducer parts can be damaged.
7. MAINTENANCE
•
The Shaft-30 automatic system does not require any special servicing.
•
Repairs may be carried out only by a qualified technician trained and certified at an authorized DoorHan centre.
•
Be sure that after completion of installation the installer has shown the user how to release the door in case of emergency
and has given instructions on proper operation and maintenance of the automated system.
•
When carrying out maintenance, it is recommended to use DoorHan original spare parts.
•
Carry out maintenance of the automatic system at least every six months.
•
Regularly check if the door is properly balanced and moves smoothly when automatically operated.
•
Regularly check if the extreme positions of door travel are properly adjusted and safety devices are in good working
condition.
•
In case of power failure you may need to restore operator's settings. Once the power supply is restored, check the
automatic system for proper operation. If the operator settings have changed reprogram them following the instructions
given in the corresponding paragraph of this manual (pay special attention to operation mode setting).
In case of power failure the door will stop. As soon as power supply is restored you can control the operator as usual.
•
•
After expiration of life time, the item shall be delivered in a specialized disposal point!
•
If you have lost this Manual, you may request for the duplicate copy to the following address: Kralovsky VRCH 2018,
Kadan, 43201, Czech Republic, or by e mail: [email protected].
•
The producer (DoorHan) does not supervise the installation of operators, or carry out their maintenance, thus DoorHan
cannot be held liable for safety of installation, operation and maintenance of the equipment.
8
MANUAL CONTROL OF OPERATOR
Pull