amerivap Steamax Panduan Petunjuk Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pembersih Uap amerivap Steamax. amerivap Steamax 15 halaman. Steam vapor cleaning system
Halaman Cetak
Using the
BOILER FILLING
• Fill with tap water only.
• Make sure that the Steamax™ is not
plugged into an electrical outlet.
• Place the Steamax™ on a flat surface.
• Unscrew the boiler cap. (C in Figure 2).
The boiler has maximum capacity of
2.4 quarts.
• Insert the tip of the filler bottle filled
with tap water and push down. When
the boiler is full, filler bottle will stop
automatically.
• Close the boiler cap again.
Important: Do not over fill. Use only tap
water; do not add chemical
detergents or any other
chemical additive.
CONNECT TO 110/115V POWER
Important: The Steamax™ unit requires power sockets and extension cords
6
Figure 5
E
D
(if used) that are rated at 15A or higher. Insufficient voltage and
current may damage the product.
Steamax
Figure 4
• Unwind the cord completely and plug
into a 110-115V electrical outlet.
• The green power Light (A, Figure 2)
will come on indicating that the
Steamax™ has been connected and is
being powered up.
• Press the lower boiler-heating switch
(B, Figure 2). The light in this switch
will come on indicating that the water
in the boiler is being heated.
(This will take approx. 10 minutes.)
• Wait until the control light (E, Figure 5)
comes on to indicate that the pressure
of the water in the boiler has reached
its operation level and the Steamax™
is ready for use.
TM
unit