Astralpool HALO HUB Panduan Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Peralatan Pencahayaan Astralpool HALO HUB. Astralpool HALO HUB 12 halaman. Automation expansion module
Halaman Cetak
HALO
®
HUB
™
Installation Manual
Follow the prompts, turn off the power to the Halo
Hub for 3 seconds, then turn it back on.
If the signal strength is strong enough pairing will be
automatic. After pairing, the signal strength is shown
as a bar graph in the connected devices view: A signal
of 2 "bars" or better is desirable for robust connections.
If the signal displays 1 bar, consider moving the device
closer to the Halo Chlor.
4.
Define what equipment you want to assign to
each one of two GPO's. Press the button of the
Halo Hub and press "Edit".
5.
On the next screen, enable or disable each
GPO (outlet 1 and outlet 2) and define which
equipment should be plugged into each outlet.
NOTE: – Solar pumps must use outlet 1.
– If a heater is being controlled by a GPO, the
heater unit must use outlet 1.
6.
To enable the use of valves or relays, press "Next"
on the screen above and use the sliders to enable
the features that you require.
Press OK to leave this menu.
For information on the use of relay 1, and input 1 or 2,
see Appendix 2.
If you are adding a heater, press the "Add/Remove"
button and then press "Heater".
•
On this screen you can choose how you wish to
control the heater.
•
"Heat Pump Interface" and "Genus" uses the
chlorinator RJ12 connector.
•
"IXI" uses the chlorinator RS485 connector.
7