DoorHan ARM 320 Panduan Instalasi dan Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Sistem pembukaan pintu DoorHan ARM 320. DoorHan ARM 320 12 halaman. Operator
Juga untuk DoorHan ARM 320: Manual (2 halaman)

Halaman Cetak

7. MAINTENANCE

• The Arm-320 automatic system does not require any special servicing.

• Repairs may be carried out only by a qualified technician trained and certified at an authorized DoorHan centre.

• Be sure that after completion of installation the installer has shown the user how to release the door in case of emergency

and has given instructions on proper operation and maintenance of the automated system.

• When carrying out maintenance, it is recommended to use DoorHan original spare parts.

• carry out maintenance of the automatic system at least every six months.

• Regularly check if the gate moves smoothly when automatically operated.

• Regularly check if the extreme positions of the gate travel are properly adjusted and safety devices are in good working

condition.

• In case of power failure you may need to restore operator's settings. Once the power supply is restored, check the auto-

matic system for proper operation. If the operator settings have changed reprogram them following the instructions given

in the corresponding paragraph of this manual (pay special attention to Operation time programming).

• In case of power failure the door will stop. As soon as power supply is restored you can control the operator as usual.

• After expiration of life time, the item shall be delivered in a specialized disposal point!

• If you have lost this Manual, you may request for the duplicate copy to the following address: DoorHan s.r.o., Kralovsky

vrch 2018, 432 01, Kadan, czech Republic, or by e mail: [email protected].

• The producer (DoorHan) does not supervise the installation of operators, or carry out their maintenance, thus DoorHan

cannot be held liable for safety of installation, operation and maintenance of the equipment.

8. TROUBLESHOOTING

Symptom

Operator does not run

Operator stops suddenly

The gate does not open or close completely

possible reason

power to the operator is turned off or cut

There is an obstacle to gate movement

Bad connection of electric wires

The operator is released

The operator's thermal protection activates

Wrong adjustment of limit switches

Wrong operator programming

MAIntenAnCe

Solution

check, that power to the operator is on

Remove the obstacle

check wiring

Engage the operator

Let the operator cool

Adjust the limit switches

Reprogram the operator