DoorHan PCB-SW Manual Petunjuk Pemrograman - Halaman 18
Jelajahi secara online atau unduh pdf Manual Petunjuk Pemrograman untuk Panel Kontrol DoorHan PCB-SW. DoorHan PCB-SW 20 halaman. Control board
Juga untuk DoorHan PCB-SW: Manual Petunjuk Pemrograman (20 halaman)
Halaman Cetak
2.4. DISPLAY INDICATION
The display consists of two eight-segment indicators. They show the status of the control board switching contacts and of the gate.
Indicator
0
1
NOTES:
After 3 minutes of idle operation energy saving mode activates (the display will go put). Press any button to resume
the display operation.
In the energy saving mode the power supply of the photocells is turned off, terminal X7.
2.5. RESET TO FACTORY SETTINGS
To reset the control board parameters to factory settings enter the advanced programming menu and select «9.8» item, press
the «P» button. The display will show «rE», press and hold the «P» button for five seconds. «rE» will stop flashing and the board
will be reloaded; short audio signal will be given. After this operation, all settings will be default.
NOTE:
Resetting to factory settings won't erase receiver memory.
18
Segment
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
OPERATOR PROGRAMMING
Description
Lights when the «FOTO OP» contact is closed
Not used
Not used
Lights when the «FOTO CL» contact is closed
Lights when the «PED» contact is closed
Lights when the «SBS» contact is closed
Lights when the «STOP» contact is closed
Not used
Indication of the processor operation
(segments are switched clockwise)