Astralpool Starlight Hoop Petunjuk Manual - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Peralatan Pencahayaan Astralpool Starlight Hoop. Astralpool Starlight Hoop 8 halaman.

Assembling the hoop

The Starlight comes with a push button connector. Simply insert the battery with the

positive side towards the end of the tube and push one end of the hoop into the other

until both ends are flush together and the button pops through the hole. To turn off the

hoop, open the hoop to the second push button position or remove the battery.

Included with this model are two rechargeable 10440 3.7V Li-Ion batteries and a battery

charger. To charge a battery, follow the directions indicated on the battery charger. Only

use battery chargers compatible with the 10440 3.7V Li-Ion battery. DO NOT INSERT THE

BATTERY BACKWARDS.

Taking the hoop apart

The push button is sometimes a little tight. We prefer tight over loose since it wouldn't be

very nice for a hoop to fly open during a performance. Here's a trick that makes it quite a

bit easier: it helps to push on the button with a rigid object instead of with your finger.

The end of a ballpoint pen (with the point still retracted) fits nicely over the button and

works well for this. As you push the button, give the hoop a little twist so the push

button goes under the hoop surface, then pull apart. With a little practice using this

method, taking the hoop apart becomes much easier.

Coiling down the hoop for travel and shipping

If you need to coil the hoop later for shipping or travel, be careful not to coil the tubing

any more than necessary and never smaller than 20" diameter. Coiling it too small can

cause the tubing to crease, crack, or shatter. We highly suggest using painter's tape

instead of duct tape in the event that you need to coil your hoop down.

Using the hoop

Selecting a pattern

Hold the hoop with the menu lights going out away from you. When in the selection

menu, each light on the hoop represents a different pattern. Use the left, right, forward,

and back buttons on the remote to move the cursor around the menus. To run the

selected pattern, press OK on the remote. To return to the menu again press the menu

button. This is in the top left corner of the remote with the three lines icon.

The first yellow mode in the white menu is an all hoop shuffle, so you can turn the hoop

on and immediately start playing with all of the patterns!

Presets (white menu)

The first menu is where you can save up to 9 of your favorite patterns for quick access. If

you try to select a location in the preset menu that does not already have a pattern

stored, the cursor will blink red.

To store patterns in the preset menu, go to the pattern you would like to store. While

the pattern is running, press the save button on the remote. This is the button in the top

right corner with the disk icon. The hoop will then go back to running that pattern and it

will be stored in the chosen preset location for later access. If you choose a location that

already has a pattern stored in it, that preset will be overwritten with the new pattern.

You can not save the yellow or purple scan modes.