5.10
The The Card Slot is already mapped as Network Drive to this computer is
displayed during setup
The Card Slot has already been mapped as the network drive. The Card Slot is already available.
Click OK to close the dialog, then click Next on the Network Setup of the Card Slot dialog box.
5.11
The Cannot map any more drives, because all the drive letters are assigned is
displayed during setup
Click Skip to complete the setup. After software installation is complete, remove any drive letter
and try the network setup of the Card Slot again using the Canon IJ Network Tool.
5.12
The Timeout error screen is displayed during WPS setup
This screen is displayed when WPS setup is not completed within the specified time (2 minutes for
the push button method, and 10 minutes for the PIN code method). Retry following the procedures
below.
•
When using the push button method
Press the OK button.
a)
The WPS setting screen returns.
Select Push button method and press the OK button.
b)
Press the OK button.
c)
When the access point is ready, press the OK button on the machine, then press the WPS
d
button on the access point within two minutes.
•
When using the PIN code method
Press the OK button.
a)
The WPS setting screen returns.
Select PIN method and press the OK button.
b)
A new PIN code appears.
Set the new PIN code to the access point or computer.
c)
6 Re-setting the machine
6.1
Re-setting the machine
•
Restore the machine to the factory default and set up the machine again. For details, refer to
"Restoring the Machine to the Factory Settings" on page 8.
To set up the machine again, follow the procedures in "Install the Software" and onward in the
printed manual: Getting Started.
•
If you have changed the connection method via Change wireless/wired in the machine's LAN
setting, you need to setup the machine again. To do so, follow the procedures in "Install the
Software" and onward in the printed manual: Getting Started.
7 The admin password set to the machine was forgotten
7.1
The admin password set to the machine was forgotten
Restore the machine setting to factory default.
All settings previously set will be lost after initialization. Set up the machine again to use it. For
details, refer to "6.1 Re-setting the machine" on page 7.
8 Changing the port name
8.1
Changing the port name
To change the port name, click View Setup Results in the Setup Completion dialog box, then
click Set Port Name.
The Set Port Name dialog box is displayed, where you specify the port name. By changing the
port name, you can change the name of the machine. When you set up an additional computer to
use the machine whose port name you changed, the machine is displayed with the changed port
name. When two or more computers are set up, the changed name is displayed. When multiple
computers or machines are present, this can be used to change the name to one that is easy to
remember.
Port Name
Port names should consist of alphanumeric characters and be no longer than 21 characters,
excluding the prefix. The port name includes the fixed prefix "CNBJNP_", which you do not need
to enter.
7
Halaman Cetak