Canon PIXMA MX410 Series Pemecahan Masalah Pengaturan Jaringan - Halaman 12

Jelajahi secara online atau unduh pdf Pemecahan Masalah Pengaturan Jaringan untuk Semua dalam Satu Printer Canon PIXMA MX410 Series. Canon PIXMA MX410 Series 46 halaman. Cartridge reset
Juga untuk Canon PIXMA MX410 Series: Panduan Instalasi Jaringan (23 halaman), Spesifikasi (2 halaman), Manual Fungsi (30 halaman), Manual Fungsi (21 halaman), Manual Fungsi (15 halaman), Panduan Pengaturan Jaringan (24 halaman), Panduan Pengaturan Jaringan (20 halaman), Menu Manual (34 halaman), Manual (14 halaman), Manual (4 halaman)

Halaman Cetak
Canon PIXMA MX410 Series Pemecahan Masalah Pengaturan Jaringan

Connection Checklist

Check 1
Before connecting the machine, are the computer and network device (router, access
point, etc.) configured and can the computer connect to the network?
Configure the computer and network device.
•
For the procedures, refer to the manuals supplied with the computer and network device, or
contact their manufacturers.
Check 2
Are the machine and network device (router, access point, etc.) turned on?
Turn on each device.
If the machine is already turned on, turn it off, then turn it back on.
Check 3
Are the access point and machine installed in an open space where wireless
communications are possible? Also, is there a microwave oven, refrigerator, etc.
nearby?
Install them in an open space with as few obstacles as possible.
Leave some space between the installation location and a microwave oven,
refrigerator, etc. so that its radio waves will not affect those from the access point and
the machine.
Glossary
•
Firewall
A system to use computers connected to the Internet and corporate networks safely. It protects computers and corporate networks against unauthorized access, or restricts unauthorized access to corporate
networks and the Internet.
Check 4
Is the access point operating in IEEE802.11n, IEEE802.11g, or IEEE802.11b (2.4
GHz)?
•
For details on how to check the operating mode of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
Set the access point to operate in IEEE802.11n, IEEE802.11g, or IEEE802.11b (2.4
GHz).
•
For details on how to change the operating mode of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
Check 5
Is the network setup cable connected properly?
•
The network setup cable is required for network settings when configuring wireless settings
without using the WPS or WCN function.
Connect the network setup cable properly.
•
For the connection procedure, refer to "Software Installation (1)" in the printed manual: Getting
Started.
Check 6
Is the firewall function of your security software active?
A message may appear on the computer monitor warning that Canon software is
attempting to access the network.
If the warning message appears, set the security software to always allow access.