dacell DN-AM210 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat dacell DN-AM210. dacell DN-AM210 14 halaman. Dynamic strain amplifier

⑨ Bridge voltage selecting switch

This switch is to select the bridge supply voltage.

You can make your selection for the supply voltage among DC 1V, 2V, 5V,

7.5V, 10V.

⑩ Sensor input connector

You can use Strain gauge type sensor as well as Potentiometer Voltage input.

⑪ High-current output (more than 200 Ω load) connector

It is the final output signal of Amplifier and also high-current output.

You can use this on more than 200Ω load.

⑫ Low-current output (more than 2kΩ load) connector

It is the final output signal of Amplifier and also low-current output.

You can use this more than 2kΩ load.

⑬ Internal CAL bridge resistance selecting switch

This switch is to select the bridge resistance while you are doing bridge

calibration.

⑭ Power input connector

This connector is to supply external AC power.