Akw M11 DigiPump Petunjuk Instalasi dan Perawatan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Perawatan Pengguna untuk Produk Pipa Akw M11 DigiPump. Akw M11 DigiPump 20 halaman.

Fixing pump to surface

Check that the flow is in the required direction, reverse as required.

Loosen the pump head housing, rotate and fully tighten home.

The pipework to this high performance pump must be clamped down effectively-

AKW advise and recommend you clamp pipework either side of joints, junctions or

connections and at a maximum of 500mm between other supports

REMOVE SHIPPING

TAPES from ends.

Refit the pump to the

back plate.

Reconnect cable.

Fit the pump connectors

to the pump. Note 15mm

connector for the inlet.

Screw both ends into

place. No thread sealant

needed, firmly hand

tighten only.

Check that you have not overtightened and

distorted the valves before connecting the pipework.

Refit the front cover.

Rotate to direction of flow

Loosen

Insert

Fully tighten

Insert

Flow direction

from the front.