Astria Fireplaces Rhapsody54 Series Panduan Petunjuk Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Perapian Astria Fireplaces Rhapsody54 Series. Astria Fireplaces Rhapsody54 Series 12 halaman. Linear direct-vent fireplaces accessory kits

Halaman Cetak

APPENDIX: ALTERNATE INSTALLATION INSTRUCTIONS

Route and connect optional ﬁ rebox panel backlight kit

wiring and install lamp assemblies

NOTE: These instructions should be used in place of Route and

connect optional ﬁ rebox panel backlight kit wiring and install

lamp assemblies on Page 6, for ﬁ replaces without backlight

wiring kit routing holes as shown in Figure 14 on Page 6.

1. Route one set of three leads (white/green/black) through

the hole in the front of the bracket (Figure 33).

Front of Mounting Bracket

Figure 33 - Routing wires through lamp bracket

f i r e - p a r t s . c o m

2. Connect the green wire to the lamp (Figure 34).

Figure 34 - Attaching green wire to ﬁ rebox panel backlight

kit lamp, and inserting lamp into lamp bracket

3. Insert the lamp (with green wire attached) into bracket until

the spring clip is engaged (Figure 34).

4. Connect the white (neutral) wire, and black (hot) wire

(Figure 35).

IHP reserves the right to make changes at any time, without notice, in design, materials,

speciﬁ cations, prices and also to discontinue colors, styles, and products. Consult your local

distributor for ﬁ replace code information.

P/N 900077-05 Rev. A 09/2016

INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES

Figure 35 - Attaching black and white wires to ﬁ rebox

panel backlight kit lamp

5. Repeat the process in step 1 through step 4 for the two

remaining lamp assemblies.

6. Carefully lay the ﬁ rebox backlight lamp assemblies and

wiring on the ﬁ replace ﬂ oor. The lamp assemblies will not

be installed until the back panel is installed (in a later step).

7. Remove the three (3) cover plates in the lower front face

of the back panel. Discard the cover plates, but retain the

screws.

8. Insert the three (3) previously assembled lamp assemblies

in the orientation shown (Figure 36).

NOTE: The wires will be routed under the rear ﬂ oor section

in the next step.

9. Secure the lamp assemblies using the six (6) previously

removed screws from the cover plates.

Cover Plate

Note orientation of each

lamp assembly.

Figure 36 - Installing the lamp assemblies

NOTE: When installing the rear ﬂ oor, route the ﬁ rebox

backlight wiring through the notches under the rear ﬂ oor

section. Be careful not to pinch or damage the wires.

1508 Elm Hill Pike, Suite 108, Nashville, TN 37210