Astria Fireplaces SIRIUS42TEP Petunjuk Perakitan dan Pemasangan - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Perakitan dan Pemasangan untuk Aksesori Perapian Astria Fireplaces SIRIUS42TEP. Astria Fireplaces SIRIUS42TEP 2 halaman. Surround kit for contemporary linear view gas fireplaces

Halaman Cetak

INNOVATIVE HEARTH PRODUCTS • CONTEMPORARY LINEAR VIEW DIRECT-VENT GAS FIREPLACE • REQUIRED AND OPTIONAL ACCESSORIES

Step 2. Installing the gas shut-off valve;

a. Pull gas flex line out from inside, beneath fireplace

floor.

b. Place shut-off valve in valve bracket, threading flex

line through gap in back.

c. Use coupler to attach additional flex line to shut-off

valve.

d. Bend up tab on the side of valve bracket to hold

shut-off valve in place (Figure 3).

e. Attach valve bracket to unit with two screws.

f. Attach shut-off valve to incoming gas line with field-

supplied coupler.

Gap

(thread

flex

gas line

here)

Back Side

Figure 3: Gas Shutoff Valve Bracket

f i r e - p a r t s . c o m

Step 3. Place unit in wall framing.

NOTE: The provided non-combustible fiber board

may be faced with any NON-combustible finish

material appropriate for use (brick, tile, stone, high-

temperature paint, etc.). For painted wall finish, use

two (2) coats of quality primer and high-temperature

paint on provided fiber board.

Step 4. Secure nailing flanges to wall framing.

Step 5. Secure heat shield to top front of unit with two screws.

Printed in U.S.A.

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.

P/N 900079-08 Rev. NC 03/2015

Tab (bend up

to hold valve)

P900079-08

NOTE: Refer to the Instruction Manual (P/N

900079-02 for finishing details.

Step 6. Place insulation flat across the top of the fireplace

lengthwise behind heat shield.

Step 7. Cut noncombustible fireboard to size and install

flush with top of frame pieces.

Step 8. Finish out wall with ½" finishing materials – paint

with high-temperature paint, etc.

Step 9. Attach surround in frame using screws a minimum

of six at specified locations (Figure 2).

Step 10. Install barrier mounting brackets on side of

surround.

Step 11. If removed, reinstall door and secure with three

screws.

Step 12. Install Gas Shutoff Valve Door (Figure 1).

Step 13. Install barrier on barrier mounting brackets.

Figure 4: Attach the Surround to the Fireplace

1508 Elm Hill Pike, Suite 108

Nashville, TN 37210

IHP.us.com