Astria Fireplaces SIRIUS54TEP Petunjuk Perakitan dan Pemasangan
Jelajahi secara online atau unduh pdf Petunjuk Perakitan dan Pemasangan untuk Aksesori Perapian Astria Fireplaces SIRIUS54TEP. Astria Fireplaces SIRIUS54TEP 2 halaman. Surround kit for contemporary linear view gas fireplaces
Halaman CetakASSEMBLY AND INSTALLATION INSTRUCTIONS FOR SURROUND KITS
FOR USE ON CONTEMPORARY LINEAR VIEW DIRECT-VENT GAS FIREPLACES
[MODEL NUMBERS SIRIUS42TEN/P AND SIRIUS54TEN/P]
Barrier
Mounting
Bracket
f i r e - p a r t s . c o m
(bottom)
Gas Shutoff
Valve Door
Figure 1: Linear View Surround
Size
42 in. Surround
Stainless Steel
54 in. Surround
Stainless Steel
Table 1: Surround Kits for Contemporary Linear View Gas
Fireplaces
KIT CONTENTS
• Stainless Steel Surround
• #10-16 x 3/8 Hex-head sheet metal screws
• Gas Line Extension and Bracket
• These Instructions
REQUIRED TOOLS
• 3/8 in. Hex-head nut driver
• Safety glasses
• Protective work gloves
NOTICE
• READ ALL STEPS BEFORE STARTING INSTALLATION.
• LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
• All warnings, precautions, and instructions in the Installation
Instructions and Care and Operation Manual provided with the
appliance also apply to these instructions.
• If you encounter any problems, need clarification of these
instructions, or are not qualified to properly install this kit, contact
your local distributor or dealer.
P/N 900079-08 Rev. NC 03/2015
Finish
Cat. No.
F2263
F2262
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.
P900079-08
FOR CONTEMPORARY LINEAR VIEW GAS FIREPLACES
DO NOT TOUCH GLASS UNTIL COOLED.
NEVER ALLOW CHILDREN TO TOUCH GLASS.
• Install only when fireplace is OFF and COLD.
• Fireplace surfaces get EXTREMELY HOT!
• The glass on the front of the fireplace reaches EXTREMELY HIGH
temperatures and can cause severe burns if touched. Even after
the gas is turned off, fireplace surfaces remain extremely hot.
• A barrier designed to reduce the risk of burns from the hot viewing
glass is provided with this appliance and shall be installed for the
protection of children and other at-risk individuals.
GENERAL INFORMATION
This document contains instructions for assembling and
installing the enclosed surround for use with Contemporary
Linear direct-vent gas fireplaces manufactured by Innovative
Hearth Products.
NOTE: For easier installation, remove the fireplace front
door before installing the surround. Refer to the Refer to the
Installation Instructions and Care and Operation (PN 900079-
02) for more information.
NOTE: Make sure you have the correct kit and all required
parts before starting installation.
INSTALLATION INSTRUCTIONS
NOTE: Ensure the work surface is free of debris that
may damage the surround finish. Any such DAMAGE
IS NOT COVERED by the manufacturer's warranty.
When the work surface is ready, peel the clear
protective plastic film from all surround sections.
Step 1. Lift barrier up from mounting brackets and pull away
from fireplace. Remove clean-face frame (Figure 2).
Figure 2: Clean Face Frame (Shaded)
IHP.us.com
HEARTH PRODUCTS
KITS AND ACCESSORIES
SURROUND KIT
DANGER
HOT GLASS WILL CAUSE BURNS.
1