AIR GAP AG250-003 Instruksi

Jelajahi secara online atau unduh pdf Instruksi untuk Unit Kontrol AIR GAP AG250-003. AIR GAP AG250-003 4 halaman. Cold/hot potable water electrical valve

Halaman Cetak
VALVE TO PEDAL CONNECTION (SEE FIG. 2)
Connect 3.5mm Female Cable from the valve to the 3.5mm Male
1.
Cable on the pedal. See pedal installation on manual for the pedal.
FIG. 2
CAUTION:
AG250-003 Valve is battery operated ( AA type, 4pcs included)
Change battery instruction.
Disconnect cable connection between
1.
battery pack and valve.
Remove Battery pack from valve body.
2.
3.
Open battery pack by removing a screw
on the bottom of battery pack.
4.
Replace batteries, following "+" and
"_" sign.
Close battery pack by installing the
5.
screw. Install battery pack into valve unit
in original place.Squeeze metal tab if
needed to hold battery pack in place.
6.
Connect 2.5 mm power plug cable
from battery pack to 2.5mm power
jack on the valve body (see FIG 3.)
500 Jefferson Street, Placentia, California 92870 USA • 949-955-3928 • Email: [email protected]
Battery pack
2.5 mm
Power Plug
cable from
battery pack
Copyright 2019 AIR GAP INTERNATIONAL
AG250-003
Model:
TAP-A-TAP™
COLD/HOT POTABLE
WATER ELECTRICAL
VALVE
Part No.
AG250-003
Doc. # 400-0787-003
Placentia, California