Acer Add-In-One Series Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Desktop Acer Add-In-One Series. Acer Add-In-One Series 12 halaman.

Halaman Cetak
1
Acer Add-In-One series Guide (QSG)

Important safety instructions

Please read the following instructions carefully.
1
To clean the monitor screen:
•
Turn off the docking monitor and unplug the power cord.
Spray a non-solvent cleaning solution onto a rag and clean the screen gently.
•
2
Do not place the docking monitor near a window. Exposing the monitor to rain, moisture or
sunlight can severely damage it.
3
Do not apply pressure to the LCD screen. Excessive pressure may cause permanent
damage to the screen.
4
Do not remove the cover or attempt to service this unit yourself. An authorized technician
should perform servicing of any nature.
5
Store the monitor in a room with a temperature of -20° to 60° C (-4° to140° F). Storing the
monitor outside this range may result in permanent damage.
6
Immediately unplug your monitor and call an authorized technician if any of the following
circumstances occur:
•
Monitor-to-PC signal cable or adapter power cord is frayed or damaged.
Liquid spills onto the docking monitor or system or it is exposed to rain.
•
•
The panel or adapter is damaged.
Attach the monitor to the base (refer to the setup poster)
1
Take out the docking monitor, stand, base and system from the packaging (miniPC or
Chromebox is optional).
2
Putting the docking monitor (panel down) on a flat surface.
3
Attach the stand on the back of monitor.
4
Take the base and tighten the stand with four screws by a screwdriver.
Connect your docking monitor to the bundled Acer Chromebox or Acer Veriton
miniPC (Specific models only: CXI series and VN series)
1
Assemble Chromebox or miniPC into the docking monitor by following the setup poster.
2
Connect the Type-C cable in the box to the Type-C input socket of the monitor.
3
Tighten the screw into the bundled Type-C cable of the monitor.
4
Tighten the screw into the system holder of the monitor.
5
Plug the power adapter DC jack at the back of the monitor
6
Plug the power cord with the adapter into a nearby electrical outlet.
Connect your docking monitor to a computer with HDMI output port (use as the
monitor mode)
1
Turn off your computer and unplug your computer's power cord.
2
Connect HDMI (optional) cable into HDMI input socket at the back of the monitor.
3
Connect the USB Type-B Cable (optional).
Acer Add-In-One series Guide (QSG)