Canon 500F - CanoScan LiDE Panduan Memulai Cepat - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pemindai Canon 500F - CanoScan LiDE. Canon 500F - CanoScan LiDE 22 halaman. Color image scanner - using the stand
Juga untuk Canon 500F - CanoScan LiDE: Panduan Cepat (2 halaman)
Halaman Cetak
Scanning Film
Scanning Film
This scanner can scan 35 mm film strip one frame at a time.
Preparing to Scan Film
Use the following procedures to place the film adapter unit and the film guide on the document glass to
scan film.
• You cannot scan film with the scanner in the upright position.
• Clean the document glass before placing the film guide on it, otherwise dirt and dust
can affect image quality or damage the film.
• Use a blower brush to remove any dust from the film, which will affect the image
quality, and take care to hold the film by its edges to avoid transferring dirt or
fingerprints to it.
1
Attach the cable for the film adapter unit to the FAU
connector on the scanner's side panel.
2
Open the document cover and place the film guide
on the document glass of the scanner.
Fit the two tabs on the film guide into the document glass slots.
• When opening the document cover, support it
with your hand until it stops.
Calibration
Calibration is required when film is first scanned. Calibration is the
process ScanGear CS uses to adjust to the correct color balance. If there is film in the film guide, remove it
before setting the film adapter unit on it.
1
Remove the cap from the film adapter unit and
gently set the film adapter unit over the first
frame in the film guide.
Align the tab on the film adapter unit with the film guide.
• Be careful not to lose the cap or to
allow dirt into it.
16