Canon CanoScan FS2710 Panduan Produk - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Produk untuk Pemindai Canon CanoScan FS2710. Canon CanoScan FS2710 31 halaman.
Halaman Cetak
35 mm Positive Film (Mounted Slides)
•
Follow the procedures below to insert mounted positive films (mounted slides)
directly into the scanner.
1.
Open the dust cover.
•
Using your fingertips, grasp the notch on either side of the dust cover and pull
it gently down.
2.
Insert the slide into the scanner, orienting it so that the image is
correctly viewed from the left.
•
Insert the slide as far as it will go.
•
The image will not be correctly scanned if the slide is inserted at an angle.
•
Insert the slide so that the short edge faces the film guide.
•
If a slide is inserted at an angle and becomes jammed in the slot, open the
film guide and remove it.
•
The orientation of an image can be corrected with the rotate command of
the scanning software, CanoCraft FS or Plug-in module FS, if the slide is
reversed or inverted.
CanoScan FS2710 Film Scanner
18
Dust Cover