Flying Dog Grape Gym-Star Manual - Halaman 5
Jelajahi secara online atau unduh pdf Manual untuk Mainan Flying Dog Grape Gym-Star. Flying Dog Grape Gym-Star 8 halaman.
Halaman Cetak
9.
Hinge
End of
CF horn
90°
9.
Taken from another airframe, this picture shows
the correct orientation of servo horn
hinge line and aileron horn.
11.
The servos were glued using POR into holes cut
in the under-wing braces. We adjusted the position
of the braces to suit the length of wires on the servo,
but obviously don't deviate wildly from the photos.
Z-bends were CA glued and heatshrunk to the
carbon push-rods at the servo horn end before being
cut to length so that the carbon lines up with the
hinge line.
Join the pushrod and aileron horn using a short
length of heatshrink as a hinge. With the pushrods
fitted to the servo, mark and cut slits for the aileron
horns, bonding the horns with CA after making sure
the servos are centred.
12.
12.
Attach the upper vertical fuselage to the lower
assembly. Check that it's straight and square.
5
The biased arm should faces forward (like the horns on a bull).
6
The angle between the servo centre, linkage hole and the aileron horn is 90° .
5
, push rods,
6
10.
10.
Two Servo option: The RX was placed on the
underside of the wing and the servo wires pushed
into slits, cut with a scalpel, to neaten the whole
installation.
11.
13.
13.
On a flat surface, weight down the wings and
glue on the fuselage assembly. Check the whole
thing is square and attach the 1.5mm wing braces.
The ends of the braces are pushed into small slits
4