Canon imageFORMULA CR-135i High-Volu Panduan Pengoperasian & Pemeliharaan - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengoperasian & Pemeliharaan untuk Pemindai Canon imageFORMULA CR-135i High-Volu. Canon imageFORMULA CR-135i High-Volu 31 halaman. Canon scanners
Juga untuk Canon imageFORMULA CR-135i High-Volu: Brosur & Spesifikasi (26 halaman), Brosur & Spesifikasi (2 halaman)
Halaman Cetak
Document Feeding and Scanning
This section describes how to load and scan documents.
CAUTION
• Avoid wearing loose fitting clothing, dangling jewelry, long ties,
or long hair that could become entangled with moving parts,
especially the rollers that feed paper through the scanner. If
such objects become entangled, immediately disconnect the
power plug from the power outlet.
• Check the paper stack and remove all clips, staples, pins, or
any other type of metal or plastic fastener. These objects may
cause damage to the document, a paper jam, or a scanner
malfunction.
• Do not touch anything except the operation buttons when the
jogger is operating (CR-190i only) or documents are being fed.
• Do not touch documents that are being fed under any
circumstances. The documents that are being fed may cut your
hand.
Scan Procedure
1
Carefully align the edges of the document.
2
Place the first page of the document facing you, and place
the leading edge of the document into the scanner.
The remaining procedure differs depending on the scanner you
are using.
For the CR-135i: Proceed to step 4
For the CR-190i: Proceed to step 3
3
(CR-190i only) If the documents are not aligned, press the
JOG Button.
The jogger mechanism can be used to align documents.
IMPORTANT
• If you press the JOG Button when a batch of documents of various
sizes are loaded, the alignment will be incomplete, and the
documents will not be scanned in the order loaded. If you are
scanning documents of various sizes, align the leading edges of all
the documents with the entry point of feeding.
• The jogger mechanism is not available for documents of less than
5.9" (150 mm) in length.
NOTE
• The jogger does not work when the shutter is open. It occurs on the
following conditions:
• The STOP Button is pressed and the scanning stops.
• There are documents on the document tray when a paper jam
occurs.
Remove the documents from the document tray to close the shutter.
If the jammed document remains or the Top Cover is removed, the
jogger does not work.
• The jogger vibrates for 6 seconds, and then stops. Press the JOG
Button to stop the jogger.
4
Adjust the Eject Stopper in accordance with the
document.
8